BS EN 1123-3:2004

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Pipes and fittings requirements
  5.1 General
  5.2 Operating pressure, operating temperature and
      tightness
6 Dimensions
  6.1 General and tolerances
  6.2 Sockets
      6.2.1 Sockets for gravity drainage systems
      6.2.2 Sockets for vacuum operation (vacuum system)
  6.3 Pipes
      6.3.1 Pipes for gravity drainage systems (gravity
            systems)
      6.3.2 Pipes for vacuum operation (vacuum systems)
  6.4 Fittings
      6.4.1 Fittings for gravity systems
      6.4.2 Flange connecting pieces
      6.4.3 Fittings for vacuum systems
      6.4.4 Other fittings
7 Seals
  7.1 General
  7.2 Seal for DN 40 to DN 70 for socket shape 1 V and 3 V
      for vacuum operation - shape M 4
  7.3 Seal for DN 40 to DN 70 for vacuum and overpressure
      operation for socket shapes 1A, 2A, and 3A - shape M 5
  7.4 Seal for DN 40 to DN 150 for operation at higher pressures
      for socket shape 1A - shape M 6
8 Testing
9 Assessment of conformity
Bibliography

Specifies requirements, dimensions and tolerances for pipes and fittings of longitudinally welded, hot-dip galvanized steel pipe with spigot and socket used for vacuum drainage systems inside and outside buildings and for gravity and vacuum drainage systems on ships and floating maritime structures.

This document specifies requirements, dimensions and tolerances for pipes and fittings of longitudinally welded, hot-dip galvanized steel pipe with spigot and socket used for vacuum drainage systems inside and outside buildings and for gravity and vacuum drainage systems on ships and floating maritime structures 1) : .above freeboard deck as long as the heeling is taken into account in the event of damage when installed above freeboard deck on passenger ships; .inside a watertight compartment below freeboard deck; .with direct connection to the outboard (not permitted below freeboard deck); .inside tanks as long as these are not filled with foreign media and are not cargo tanks. On well-anchored maritime structures, this standard applies to pipes and fittings of longitudinally welded hot-dip galvanized steel pipe with spigot and socket used in drainage systems in the living area. NOTE Pipes and fittings according to this document may also be used in central vacuum cleaning installations, in vacuum suction lifting installations, in chip transporting installations and in other waste water and process pipes as long as the media to be discharged do not damage the components or the health and safety of the personnel. For other pipes, this document only applies if agreed with the relevant operators and following prior consultation with the manufacturer. This document contains a designation system for the different types of pipes and fittings for easy identification of each component. This document is only applicable in conjunction with EN 1123-1. It does not apply to the marking of products for which EN 1123-1/A1 is applicable.