BS CISPR 16-1:1998

1 General
    1.1 Scope
    1.2 Normative references
    1.3 Definitions
SECTION 1: MEASURING APPARATUS
2 Quasi-peak measuring receivers for the frequency
    range 9 kHz to 1000 MHz
3 Peak measuring receivers for the frequency range
    9 kHz to 1000 MHz
4 Average measuring receivers for the frequency range
    9 kHz to 1000 MHz
5 RMS measuring receivers for the frequency range 9 kHz
    to 1000MHz
6 Spectrum analyzers and scanning receivers
7 Audio-frequency voltmeter
8 Reserved
9 Reserved
10 Reserved
SECTION 2: ANCILLARY APPARATUS
11 Artificial mains networks
12 Current and voltage probes
13 Absorbing clamp for use in the frequency range 30 MHz
    to 1000 MHz
14 Disturbance analyzers
15 Antennas for measurement of radiated radio disturbance
16 Test sites for measurement of radio disturbance field
    strength for the frequency range of 30 MHz to 1000MHz
17 Reverberating chamber for total radiated power
    measurement
18 Coupling units for conducted current immunity measurement
19 TEM cells for immunity to radiated disturbance
    measurement
20 Coupling devices for measuring signal lines
21 The artificial hand and series RC element
A Determination of response to repeated pulses of
    quasi-peak and r.m.s. receivers
B Determination of pulse generator spectrum
C Accurate measurements of the output of nanosecond
    pulse generators
D Influence of the quasi-peak measuring receiver
    characteristics upon its pulse response
E Response of average and peak measuring receivers
F Artificial mains networks
G Validation procedure of the open area test site for the
    frequency range of 30 MHz to 1000 MHz
H Calibration of the absorbing clamp
J Construction, frequency range and calibration of
    current probes
K Construction of the absorbing clamp
L Construction details for open area test sites in the
    frequency range of 30 MHz to 1000 MHz
M Basis for 4 dB site acceptability criterion
N Construction of the coupling units for current injection
    for the frequency range 0.15 MHz
P Principle of operation and examples of coupling units
    for conducted current immunity measurements
Q Parameters of broadband antennas
R Loop antenna system for magnetic field induced current
    measurements in the frequency range of 9 kHz to 30 MHz
S Example of an asymmetrical artificial network (T-network)
Figures 1 to S.4

Specifies characteristics and performance of equipment for measuring RF disturbance voltages, currents and fields in the frequency range 9 kHz to 18 GHz.