ASTM E 953/E953M : 2016 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Fusibility of Refuse-Derived Fuel (RDF) Ash
09-11-2023
English
30-11-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 11.04, 2016 Describes the observation of the temperatures at which triangular pyramids (cones) prepared from RDF ash attain and pass through certain stages of fusing and flow when heated at a specific rate in controlled, mildly-reducing, and oxidizing atmospheres.
| Committee |
D 34
|
| DevelopmentNote |
Supersedes ASTM E 953. (11/2008)
|
| DocumentType |
Redline
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This practice covers the observation of the temperatures at which triangular pyramids (cones) prepared from RDF ash attain and pass through certain stages of fusing and flow when heated at a specific rate in controlled, mildly-reducing, and oxidizing atmospheres.
1.2The test method is empirical, and strict observance of the requirements and conditions is necessary to obtain reproducible temperatures and enable different laboratories to obtain concordant results.
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 5681 : 2017-09 | TERMINOLOGY FOR WASTE AND WASTE MANAGEMENT |
| ASTM E 829 : 2016 | Standard Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis |
| ASTM D 5681 : 2017-09 | TERMINOLOGY FOR WASTE AND WASTE MANAGEMENT |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.