ASTM E 2113 : 2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
Hardcopy , PDF
11-11-2014
English
10-11-2000
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
E 37
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMA) over the temperature range from -100 to 600C using the thermal expansion of a suitable reference material.
1.2 Computer or electronic based instruments, techniques or data treatment equivalent to this method may be used.
Note 1--Users are advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user to determine necessary equivalency prior to use.
1.3 SI values are the standard.
1.4 This method differs from ISO standard 11359-1 by providing an alternative calibration procedure.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 2092 : 2018 : REV A | Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis |
| ASTM E 2347 : 2016 | Standard Test Method for Indentation Softening Temperature by Thermomechanical Analysis |
| ASTM E 2769 : 2018 | Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading |
| ASTM E 2918 : 2018 : REV A | Standard Test Method for Performance Validation of Thermomechanical Analyzers |
| ASTM E 2206 : 2011 : R2015 | Standard Test Method for Force Calibration of Thermomechanical Analyzers |
| ASTM E 831 : 2019 | Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.