ASTM E 2098/E2098M : 2013 : R2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Determining Tensile Breaking Strength of Glass Fiber Reinforcing Mesh for Use in Class PB Exterior Insulation and Finish Systems (EIFS), after Exposure to a Sodium Hydroxide Solution
Hardcopy , PDF
09-11-2023
English
12-09-2018
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
E 06
|
| DocumentType |
Test Method
|
| Pages |
3
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers procedures for determining the breaking force of glass fiber mesh following their conditioning in an alkali solution. The method is applicable to glass fiber mesh used in Class PB Exterior Insulation and Finish Systems (EIFS) with base coats that contain portland cement as an ingredient.
1.2Breaking force is expressed both as force per unit width of mesh and as a percentage of the breaking force of the mesh that has not been exposed to alkali conditioning.
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 2568 : 2017 : REV A | Standard Specification for PB Exterior Insulation and Finish Systems |
| ASTM C 1764 : 2020 | Standard Test Methods for Non Metallic Plaster Bases (Lath) Used With Portland Cement Based Plaster in Vertical Wall Applications |
| ASTM D 5035 : 1995 | Standard Test Method for Breaking Force and Elongation of Textile Fabrics (Strip Method) |
| ASTM E 2110 : 2017 | Standard Terminology for Exterior Insulation and Finish Systems (EIFS) |
| ASTM D 76/D76M : 2021 | Standard Specification for Tensile Testing Machines for Textiles |
| ASTM D 76/D76M : 2011 : R2016 | Standard Specification for Tensile Testing Machines for Textiles |
| ASTM E 2110 : 2000 | Standard Terminology for Exterior Insulation and Finish Systems (EIFS) |
| ASTM D 5035 : 2011 : R2019 | Standard Test Method for Breaking Force and Elongation of Textile Fabrics (Strip Method) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.