ASTM E 1651 : 1994 : R2004
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Standard Test Method for Total Luminous Reflectance Factor by Use of 30/t Integrating-Sphere Geometry (Withdrawn 2004)
Hardcopy , PDF
11-10-2004
English
10-11-1999
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 06.01, 2001 Test procedure which measures total luminous reflectance factor of opaque, non-fluorescent samples using an integrating-sphere reflectometer illuminated at an angle 30 Degree from the surface normal and diffuse viewing with specular component included.
| Committee |
E 12
|
| DocumentType |
Test Method
|
| Pages |
3
|
| ProductNote |
Reconfirmed 2004
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Withdrawn
|
| Supersedes |
1.1 This test method covers measurement of total luminous reflectance factor of opaque, nonfluorescent specimens by use of an integrating-sphere reflectometer with illumination at an angle of 30° from the surface normal and diffuse viewing with specular component included.
1.2 This test method is intended to be used for evaluation of total luminous reflectance factor of reflector lighting sheet material. It may be used for evaluation of other material when its specific geometry has been found to be applicable.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 177 : 2014 : REDLINE | Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods |
| ASTM E 284 : 2017 : REDLINE | Standard Terminology of Appearance |
| ASTM E 179 : 2017 : REDLINE | Standard Guide for Selection of Geometric Conditions for Measurement of Reflection and Transmission Properties of Materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.