ASTM D 6258 : 2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Determination of Solvent Red 164 Dye Concentration in Diesel Fuels
Hardcopy , PDF
10-08-2024
English
01-05-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.This test method covers the procedure for determining the concentration of dye Solvent Red 164 in commercially available diesel and burner fuels using visible spectroscopy.
| Committee |
D 02
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers the procedure for determining the concentration of dye Solvent Red 164 in commercially available diesel and burner fuels using visible spectroscopy.
Note 1:This test method is suitable for all No. 1 and No. 2 grades in Specifications D396 and D975 and for grades DMA and DMB in Specification D2069.
1.2The concentration ranges specified for the calibration standards are established in response to the Internal Revenue Service dyeing requirements which state that tax-exempt diesel fuel satisfies the dyeing requirement only if it contains the dye Solvent Red 164 (and no other dye) at a concentration spectrally equivalent to 3.9 lb of the solid dye standard Solvent Red 26 per thousand bbl (11.1 mg/L) of diesel fuel.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 4057 : 2019 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 4057 : 1995 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 3699 : 2019 | Standard Specification for Kerosine |
| ASTM D 3699 : 2006 | Standard Specification for Kerosine |
| ASTM D 3699 : 2002 | Standard Specification for Kerosine |
| ASTM E 131 : 2010 : R2023 | Standard Terminology Relating to Molecular Spectroscopy |
| ASTM D 396 : 2020 | Standard Specification for Fuel Oils |
| ASTM D 975 : 2022 | Standard Specification for Diesel Fuel |
| ASTM D 3699 : 2004 | Standard Specification for Kerosine |
| ASTM D 4057 : 2012 : R2018 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 396 : 1998 | Standard Specification for Fuel Oils |
| ASTM D 975 : 2019 : REV B | Standard Specification for Diesel Fuel |
| ASTM D 3699 : 2013 : REV B | Standard Specification for Kerosine |
| ASTM D 2069 : 1991 : R1998 | Standard Specification for Marine Fuels (Withdrawn 2003) |
| ASTM D 4057 : 1981 : EDT 2 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 3699 : 2018 : REV A | Standard Specification for Kerosine |
| ASTM D 975 : 2021 | Standard Specification for Diesel Fuel |
| ASTM D 3699 : 2013 : REV B : EDT 1 | Standard Specification for Kerosine |
| ASTM D 975 : 2023 : REV A | Standard Specification for Diesel Fuel |
| ASTM D 3699 : 2008 | Standard Specification for Kerosine |
| ASTM E 691 : 2020 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 975 : 2024 | Standard Specification for Diesel Fuel |
| ASTM D 3699 : 2013 | Standard Specification for Kerosine |
| ASTM E 275 : 2008 : R2013 | Standard Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers |
| ASTM E 275 : 2008 : R2022 | Standard Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers |
| ASTM D 3699 : 2005 | Standard Specification for Kerosine |
| ASTM E 169 : 2016 : R2022 | Standard Practices for General Techniques of Ultraviolet-Visible Quantitative Analysis |
| ASTM D 975 : 2020 : REV C | Standard Specification for Diesel Fuel |
| ASTM E 691 : 2019 : EDT 1 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 4057 : 2006 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM E 691 : 2023 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 3699 : 2003 | Standard Specification for Kerosine |
| ASTM E 288 : 1994 : R1998 | Standard Specification for Laboratory Glass Volumetric Flasks |
| ASTM D 4057 : 2012 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM E 131 : 2010 : R2015 | Standard Terminology Relating to Molecular Spectroscopy |
| ASTM D 3699 : 1978 | Standard Specification for Kerosine |
| ASTM E 691 : 2022 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM E 691 : 2009 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 3699 : 1998 | Standard Specification for Kerosine |
| ASTM D 3699 : 2007 | Standard Specification for Kerosine |
| ASTM E 691 : 2021 | Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
| ASTM D 3699 : 2001 | Standard Specification for Kerosine |
| ASTM D 3699 : 2018 | Standard Specification for Kerosene |
| ASTM D 975 : 2022 : REV A | Standard Specification for Diesel Fuel |
| ASTM D 396 : 2021 | Standard Specification for Fuel Oils |
| ASTM D 396 : 2009 | Standard Specification for Fuel Oils |
| ASTM D 4057 : 2022 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 975 : 2023 | Standard Specification for Diesel Fuel |
| ASTM D 3699 : 2013 : REV A | Standard Specification for Kerosine |
| ASTM E 169 : 2016 | Standard Practices for General Techniques of Ultraviolet-Visible Quantitative Analysis |
| ASTM D 4057 : 1995 : R2000 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
| ASTM D 396 : 2024 | Standard Specification for Fuel Oils |
| ASTM D 4057 : 2006 : R2011 | Standard Practice for Manual Sampling of Petroleum and Petroleum Products |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.