ASTM D 6221/D6221M : 2000 : R2014 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Reinforced Bituminous Flashing Sheets for Roofing and Waterproofing
Hardcopy , PDF
06-01-2022
English
27-05-2014
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.04, 2015 Specifies factory prepared reinforced bituminous sheet used in flashing.
| Committee |
D 08
|
| DevelopmentNote |
Supersedes ASTM D 6221. (06/2014)
|
| DocumentType |
Standard
|
| Pages |
3
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification covers factory prepared reinforced bituminous sheet used in flashing. The bitumen used may be asphalt, coal-tar pitch, or polymer modified bitumen. The reinforcement may include any one or a combination of organic (wood fiber), polyester, or glass fiber felts, woven fabrics, or thermoplastic films. Fine mineral powders, granules, or metal foils may be used as surfacing.
1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3The following precautionary statement pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 1079 : 2018 : EDT 1 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 1079 : 2008 : REV A | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 5869 : 2007 : REV A | Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials |
| ASTM D 1079 : 2016 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 1079 : 2006 | Terminology Relating to Roofing and Waterproofing |
| ASTM D 5601 : 1994 | Standard Test Method for Tearing Resistance of Roofing and Waterproofing Materials and Membranes |
| ASTM D 5869 : 2004 | Standard Practice for Dark Oven Heat Exposure of Bituminous Materials |
| ASTM D 1079 : 2020 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 5869 : 2007 : REV A : R2013 | Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials |
| ASTM D 1079 : 2013 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 1079 : 2007 : REV A | Terminology Relating to Roofing and Waterproofing |
| ASTM D 5869 : 2004 : REV A | Standard Practice for Dark Oven Heat Exposure of Bituminous Materials |
| ASTM D 1079 : 2010 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 5683 : 1995 : R1999 : EDT 1 | Standard Test Method for Flexibility of Roofing and Waterproofing Materials and Membranes |
| ASTM D 1079 : 2018 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 1079 : 2005 : REV A | Terminology Relating to Roofing and Waterproofing |
| ASTM D 5869 : 1995 : R2000 : EDT 1 | Standard Practice for Dark Oven Heat Exposure of Bituminous Materials |
| ASTM D 1079 : 2002 | Standard Terminology Relating to Roofing, Waterproofing, and Bituminous Materials |
| ASTM D 3746 : 1985 : R1996 : EDT 1 | Standard Test Method for Impact Resistance of Bituminous Roofing Systems |
| ASTM D 2523 : 2000 : R2006 | Standard Practice for Testing Load-Strain Properties of Roofing Membranes |
| ASTM D 5869 : 2007 | Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials |
| ASTM D 1079 : 2001 | Standard Terminology Relating to Roofing, Waterproofing, and Bituminous Materials |
| ASTM D 2523 : 2000 | Standard Practice for Testing Load-Strain Properties of Roofing Membranes |
| ASTM D 3746 : 1985 : R2008 | Standard Test Method for Impact Resistance of Bituminous Roofing Systems |
| ASTM D 5869 : 1995 : R2002 | Standard Practice for Dark Oven Heat Exposure of Bituminous Materials |
| ASTM D 2523 : 2013 | Standard Practice for Testing Load-Strain Properties of Roofing Membranes |
| ASTM D 1079 : 2000 : REV A | Standard Terminology Relating to Roofing, Waterproofing, and Bituminous Materials |
| ASTM D 3746 : 1985 : R2002 | Standard Test Method for Impact Resistance of Bituminous Roofing Systems |
| ASTM D 5683 : 1995 : R2005 | Standard Test Method for Flexibility of Roofing and Waterproofing Materials and Membranes |
| ASTM D 1079 : 2013 : EDT 1 | Standard Terminology Relating to Roofing and Waterproofing |
| ASTM D 1079 : 2009 | Standard Terminology Relating to Roofing and Waterproofing |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.