ASTM D 5704 : 2017 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Evaluation of the Thermal and Oxidative Stability of Lubricating Oils Used for Manual Transmissions and Final Drive Axles
05-08-2020
English
01-05-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 05.02, 2017 Describes the oil-thickening, insolubles-formation, and deposit-formation characteristics of automotive manual transmission and final drive axle lubricating oils when subjected to high-temperature oxidizing conditions.
| Committee |
D 02
|
| DocumentType |
Redline
|
| Pages |
23
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1This test method is commonly referred to as the L-60-1 test.2 It covers the oil-thickening, insolubles-formation, and deposit-formation characteristics of automotive manual transmission and final drive axle lubricating oils when subjected to high-temperature oxidizing conditions.
1.2The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.2.1Exceptions—The values stated in SI units for catalyst mass loss, oil mass and volume, alternator output, and air flow are to be regarded as standard.
1.2.2SI units are provided for all parameters except where there is no direct equivalent such as the units for screw threads, or where there is a sole source supply equipment specification.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning information is given in Sections 7 and 8 and Annex A7.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| DEFSTAN 91-59/2(2000) : 2000 AMD 2 2002 | LUBRICATING OIL, EXTREME PRESSURE, GRADE 75W, NATO CODE: O-186, JOINT SERVICE DESIGNATION: OEP-38 LUBRICATING OIL, EXTREME PRESSURE, GRADE 80W/90 NATO CODE: O-226 JOINT SERVICE DESIGNATION: OEP-220 |
| SAE J 2360 : 2012 | AUTOMOTIVE GEAR LUBRICANTS FOR COMMERCIAL AND MILITARY USE |
| ASTM B 224 : 2016 : REDLINE | Standard Classification of Coppers |
| ASTM D 6984 : 2017-05 | TEST METHOD FOR EVALUATION OF AUTOMOTIVE ENGINE OILS IN THE SEQUENCE IIIF, SPARK-IGNITION ENGINE |
| MIL L 2105 : D | LUBRICATING OIL, GEAR, MULTI PURPOSE |
| ASTM E 527 : 2016 : REDLINE | Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS) |
| ISA S7.3 : 75(R1981) | QUALITY STANDARD FOR INSTRUMENT AIR, |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.