ASTM D 5625 : 1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Measuring Length, Width, and Squareness of Sheeted Paper and Paper Products
Hardcopy , PDF
11-11-2014
English
31-12-2010
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 06
|
| DocumentType |
Test Method
|
| Pages |
3
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This test method determines the average length, width, and squareness of sheets of paper. It may also be used to determine the difference between consecutive sheets in a lot of paper. It is especially useful with printing and writing papers which have been cut to specific sizes. The procedure is applicable to a wide range of sheet dimensions, including dimensions as small as 1.6 in. (41 mm) to as large as 60.2 in. (1530 mm). While not the subject of this test method, the equipment described may be used to determine uniformity of hole punching and various process variables related to the cutting of sheeting papers.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 1968 : 2019 | Standard Terminology Relating to Paper and Paper Products |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.