ASTM D 5434 : 1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for Field Logging of Subsurface Explorations of Soil and Rock
Hardcopy , PDF
11-11-2014
English
10-12-1997
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 18
|
| DocumentType |
Guide
|
| Pages |
3
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This guide describes the type of information that should be recorded during field subsurface explorations in soil and rock.
1.2 This guide is not intended to specify all of the information required for preparing field logs. Such requirements will vary depending on the purpose of the investigation, the intended use of the field log, and particular needs of the client or user.
1.3 This guide is applicable to boreholes, auger holes, excavated pits, or other subsurface exposures such as road side cuts or stream banks. This guide may serve as a supplement to Guide D420.
1.4 This guide may not be suited to all types of subsurface exploration such as mining, agricultural, geologic hazardous waste, or other special types of exploration.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 4394 : 2017 | Standard Test Method for Determining In Situ Modulus of Deformation of Rock Mass Using Rigid Plate Loading Method |
| ASTM D 5782 : 2018 | Standard Guide for Use of Direct Air-Rotary Drilling for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices |
| ASTM D 7015/D7015M : 2018 | Standard Practices for Obtaining Intact Block (Cubical and Cylindrical) Samples of Soils |
| ASTM D 5299/D5299M : 2018 | Standard Guide for Decommissioning of Groundwater Wells, Vadose Zone Monitoring Devices, Boreholes, and Other Devices for Environmental Activities |
| ASTM D 1587/D1587M : 2015 | Standard Practice for Thin-Walled Tube Sampling of Fine-Grained Soils for Geotechnical Purposes (Withdrawn 2024) |
| ASTM D 6282/D6282M : 2014 | Standard Guide for Direct Push Soil Sampling for Environmental Site Characterizations (Withdrawn 2023) |
| ASTM E 1943 : 1998 : R2015 | Standard Guide for Remediation of Ground Water by Natural Attenuation at Petroleum Release Sites (Withdrawn 2024) |
| ASTM D 6001 : 2005 : R2012 | Standard Guide for Direct-Push Groundwater Sampling for Environmental Site Characterization |
| ASTM D 3550/D3550M : 2017 | Standard Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils |
| ASTM D 5783 : 2018 | Standard Guide for Use of Direct Rotary Drilling with Water-Based Drilling Fluid for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices |
| ASTM D 5092/D5092M : 2016 | Standard Practice for Design and Installation of Groundwater Monitoring Wells |
| ASTM D 5872/D5872M : 2018 | Standard Guide for Use of Casing Advancement Drilling Methods for Geoenvironmental Exploration and Installation of Subsurface Water Quality Monitoring Devices |
| ASTM D 6724/D6724M : 2016 | Standard Guide for Installation of Direct Push Groundwater Monitoring Wells |
| ASTM D 6169/D6169M : 2013 | Standard Guide for Selection of Soil and Rock Sampling Devices Used With Drill Rigs for Environmental Investigations |
| ASTM D 6907 : 2005 : R2016 | Standard Practice for Sampling Soils and Contaminated Media with Hand-Operated Bucket Augers |
| ASTM D 1452/D1452M : 2016 | Standard Practice for Soil Exploration and Sampling by Auger Borings |
| ASTM D 1586/D1586M : 2018 | Standard Test Method for Standard Penetration Test (SPT) and Split-Barrel Sampling of Soils |
| ASTM D 6066 : 2011 | Standard Practice for Determining the Normalized Penetration Resistance of Sands for Evaluation of Liquefaction Potential (Withdrawn 2020) |
| ASTM D 2573/D2573M : 2018 | Standard Test Method for Field Vane Shear Test in Saturated Fine-Grained Soils |
| ASTM D 4395 : 2017 | Standard Test Method for Determining In Situ Modulus of Deformation of Rock Mass Using Flexible Plate Loading Method |
| ASTM D 2113 : 2014 | Standard Practice for Rock Core Drilling and Sampling of Rock for Site Exploration (Withdrawn 2023) |
| ASTM D 4700 : 2015 | Standard Guide for Soil Sampling from the Vadose Zone (Withdrawn 2024) |
| ASTM D 6914/D6914M : 2016 | Standard Practice for Sonic Drilling for Site Characterization and the Installation of Subsurface Monitoring Devices |
| ASTM D 6151/D6151M : 2015 | Standard Practice for Using Hollow-Stem Augers for Geotechnical Exploration and Soil Sampling (Withdrawn 2024) |
| ASTM D 6725/D6725M : 2016 | Standard Practice for Direct Push Installation of Prepacked Screen Monitoring Wells in Unconsolidated Aquifers |
| ASTM D 6519 : 2015 | Standard Practice for Sampling of Soil Using the Hydraulically Operated Stationary Piston Sampler |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.