ASTM D 5337 : 2011 : R2016
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Flow Rate Adjustment of Personal Sampling Pumps
Available format(s)
Hardcopy , PDF
Superseded date
09-06-2023
Superseded by
Language(s)
English
Published date
11-11-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 11.03, 2015 Defines the calibration of sampling pumps commonly used for monitoring personal airborne exposures in the work-place.
| Committee |
D 22
|
| DocumentType |
Standard Practice
|
| Pages |
3
|
| ProductNote |
Reconfirmed 2016
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This practice describes the calibration of sampling pumps commonly used for monitoring personal airborne exposures in the work-place.
1.2This practice includes procedures for describing primary and secondary calibration techniques.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 2144 : 2021 | Standard Practice for Personal Sampling and Analysis of Endotoxin in Metalworking Fluid Aerosols in Workplace Atmospheres |
| ASTM D 6494 : 2022 | Standard Test Method for Determination of Asphalt Fume Particulate Matter in Workplace Atmospheres as Benzene Soluble Fraction |
| ASTM D 4490 : 2023 | Standard Practice for the Use of Detector Tubes in the Measurement of Toxic Gases and Vapors |
| ASTM D 8345 : 2021 | Standard Test Method for Determination of an Emission Parameter for Phthalate Esters and Other Non-Phthalate Plasticizers from Planar Polyvinyl Chloride Indoor Materials for Use in Mass Transfer Modeling Calculations |
| ASTM D 7773 : 2019 | Standard Test Method for Determination of Volatile Inorganic Acids (HCl, HBr, and HNO<inf >3</inf>) Using Filter Sampling and Suppressed Ion Chromatography |
| ASTM D 5075 : 2001 : R2022 | Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air |
| ASTM D 6562 : 2020 | Standard Test Method for Determination of Gaseous Hexamethylene Diisocyanate (HDI) in Air with 9-(N-methylaminomethyl) Anthracene Method (MAMA) in the Workplace |
| ASTM D 7201 : 2006 : R2020 | Standard Practice for Sampling and Counting Airborne Fibers, Including Asbestos Fibers, in the Workplace, by Phase Contrast Microscopy (with an Option of Transmission Electron Microscopy) |
| ASTM D 4532 : 2022 | Standard Test Method for Respirable Dust in Workplace Atmospheres Using Cyclone Samplers |
| ASTM D 7948 : 2020 | Standard Test Method for Measurement of Respirable Crystalline Silica in Workplace Air by Infrared Spectrometry |
| ASTM D 7035 : 2021 | Standard Test Method for Determination of Metals and Metalloids in Airborne Particulate Matter by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES) |
| ASTM D 6561 : 2020 | Standard Test Method for Determination of Aerosol Monomeric and Oligomeric Hexamethylene Diisocyanate (HDl) in Air with (Methoxy-2–phenyl-1) Piperazine (MOPIP) in the Workplace |
| ASTM D 7144 : 2021 | Standard Practice for Collection of Surface Dust by Micro-vacuum Sampling for Subsequent Determination of Metals and Metalloids |
| ASTM D 3686 : 2020 | Standard Practice for Sampling Atmospheres to Collect Organic Compound Vapors (Activated Charcoal Tube Adsorption Method) |
| ASTM D 6785 : 2020 | Standard Test Method for Determination of Lead in Workplace Air Using Flame or Graphite Furnace Atomic Absorption Spectrometry |
| ASTM D 4600 : 2022 | Standard Test Method for Determination of Benzene-Soluble Particulate Matter in Workplace Atmospheres |
| ASTM D 5932 : 2020 | Standard Test Method for Determination of 2,4-Toluene Di<emph type="bdit">iso</emph >cyanate (2,4-TDI) and 2,6-Toluene Di<emph type="bdit">iso</emph>cyanate (2,6-TDI) in Air (with 9-(N-Methylaminomethyl) Anthracene Method) (MAMA) in the Workplace |
| ASTM D 7202 : 2022 | Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection |
| ASTM D 5836 : 2020 | Standard Test Method for Determination of 2,4-Toluene Diisocyanate (2,4-TDI) and 2,6-Toluene Diisocyanate (2,6-TDI) in Workplace Atmospheres (1-2 PP Method) |
| ASTM D 8142 : 2017 : EDT 1 | Standard Test Method for Determining Chemical Emissions from Spray Polyurethane Foam (SPF) Insulation using Micro-Scale Environmental Test Chambers |
| ASTM D 8142 : 2017 | Standard Test Method for Determining Chemical Emissions from Spray Polyurethane Foam (SPF) Insulation using Micro-Scale Environmental Test Chambers |
| ASTM D 6562 : 2012 | Standard Test Method for Determination of Gaseous Hexamethylene Diisocyanate (HDI) in Air with 9-(N-methylaminomethyl) Anthracene Method (MAMA) in the Workplace |
| ASTM D 8208 : 2019 | Standard Practice for Collection of Non-Fibrous Nanoparticles Using a Nanoparticle Respiratory Deposition (NRD) Sampler |
| ASTM D 5955 : 2002 : R2017 : EDT 1 | Standard Test Methods for Estimating Contribution of Environmental Tobacco Smoke to Respirable Suspended Particles Based on UVPM and FPM (Withdrawn 2022) |
| ASTM E 2144 : 2011 : R2016 | Standard Practice for Personal Sampling and Analysis of Endotoxin in Metalworking Fluid Aerosols in Workplace Atmospheres |
| ASTM D 7143 : 2017 | Standard Practice for Emission Cells for the Determination of Volatile Organic Emissions from Indoor Materials/Products |
| ASTM D 7049 : 2017 | Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres |
| ASTM D 4532 : 2015 | Standard Test Method for Respirable Dust in Workplace Atmospheres Using Cyclone Samplers |
| ASTM D 5075 : 2001 : R2017 : EDT 1 | Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air |
| ASTM D 6561 : 2006 : R2016 | Standard Test Method for Determination of Aerosol Monomeric and Oligomeric Hexamethylene Diisocyanate (HDl) in Air with (Methoxy-2–phenyl-1) Piperazine (MOPIP) in the Workplace |
| ASTM D 4185 : 2017 | Standard Test Method for Measurement of Metals in Workplace Atmospheres by Flame Atomic Absorption Spectrophotometry |
| ASTM D 7200 : 2012 | Standard Practice for Sampling and Counting Airborne Fibers, Including Asbestos Fibers, in Mines and Quarries, by Phase Contrast Microscopy and Transmission Electron Microscopy (Withdrawn 2021) |
| ASTM D 7339 : 2018 | Standard Test Method for Determination of Volatile Organic Compounds Emitted from Carpet using a Specific Sorbent Tube and Thermal Desorption / Gas Chromatography |
| ASTM D 6271 : 2010 : R2016 | Standard Test Method for Estimating Contribution of Environmental Tobacco Smoke to Respirable Suspended Particles Based on Solanesol (Withdrawn 2022) |
| ASTM D 3686 : 2013 | Standard Practice for Sampling Atmospheres to Collect Organic Compound Vapors (Activated Charcoal Tube Adsorption Method) |
| ASTM D 7706 : 2017 | Standard Practice for Rapid Screening of VOC Emissions from Products Using Micro-Scale Chambers |
| ASTM D 7201 : 2006 : R2011 | Standard Practice for Sampling and Counting Airborne Fibers, Including Asbestos Fibers, in the Workplace, by Phase Contrast Microscopy (with an Option of Transmission Electron Microscopy) |
| ASTM D 7202 : 2015 | Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection |
| ASTM D 7773 : 2012 | Standard Test Method for Determination of Volatile Inorganic Acids (HCl, HBr, and HNO<inf>3 </inf>) Using Filter Sampling and Suppressed Ion Chromatography |
| ASTM D 4765 : 2013 : R2018 | Standard Test Method for Measurement of Fluorides in Workplace Atmospheres by Ion-Selective Electrodes |
| ASTM D 7295 : 2018 | Standard Practice for Sampling Combustion Effluents and Other Stationary Sources for the Subsequent Determination of Hydrogen Cyanide |
| ASTM D 1356 : 2015 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2017 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2015 : REV B | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2014 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2015 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2005 : R2010 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2020 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2000 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2014 : REV B | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2014 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2005 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.