ASTM D 4716 : 2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Determining the (In-plane) Flow Rate per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head
Hardcopy , PDF
11-11-2014
English
01-07-2008
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.09, 2013 Describes the procedure for determining the flow rate per unit width within the manufactured plane of geosynthetics under varying normal compressive stresses and a constant head.
| Committee |
D 35
|
| DocumentType |
Test Method
|
| Pages |
10
|
| ProductNote |
Reconfirmed 2008
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This test method covers the procedure for determining the flow rate per unit width within the manufactured plane of geosynthetics under varying normal compressive stresses and a constant head. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.
1.2 This test method is limited to geosynthetics that allow continuous in-plane flow paths to occur parallel to the intended direction of flow.
1.3 The values stated in SI units are to be regarded as the standard. The values stated in parentheses are provided for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 7001 : 2006 : R2011 | Standard Specification for Geocomposites for Pavement Edge Drains and Other High-Flow Applications |
| ASTM D 7273/D7273M : 2008 : R2013 : EDT 1 | Standard Guide for for Acceptance Testing Requirements for Geonets and Geonet Drainage Geocomposites |
| ASTM D 6389 : 2017 | Standard Practice for Tests to Evaluate the Chemical Resistance of Geotextiles to Liquids |
| ASTM D 6917 : 2016 | Standard Guide for Selection of Test Methods for Prefabricated Vertical Drains (PVD) |
| ASTM D 6574/D6574M : 2013 : EDT 1 | Standard Test Method for Determining the (In-Plane) Hydraulic Transmissivity of a Geosynthetic by Radial Flow |
| ASTM D 4354 : 2012 : REDLINE | Standard Practice for Sampling of Geosynthetics and Rolled Erosion Control Products(RECPs) for Testing |
| ASTM D 4439 : 2017-08 | TERMINOLOGY FOR GEOSYNTHETICS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.