ASTM D 4496 : 2004 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for D-C Resistance or Conductance of Moderately Conductive Materials (Withdrawn 2013)
Hardcopy , PDF
01-01-2013
English
01-09-2004
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 09
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This test method covers the determination of the measurement of electrical resistance or conductance of materials that are generally categorized as moderately conductive and are neither good electrical insulators nor good conductors.
1.2 Test measurements of electrical resistance (or conductance) and specimen geometry data are used to compute an electrical resistivity for the material.
1.3 This test method applies to all materials that exhibit volume resistivity in the range of 1 to 107 -cm or surface resistivity in the range of 103 to 107 (per square).
1.4 This test method is designed for measurements at standard conditions of 23C and 50 % relative humidity, but its principles of operation can be applied to specimens measured at lower or higher temperatures and relative humidities.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 8231 : 2019 | Standard Practice for the Use of a Low Voltage Electronic Scanning System for Detecting and Locating Breaches in Roofing and Waterproofing Membranes |
| ASTM D 4325 : 2013 | Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes |
| ASTM D 3004 : 2008 : R2013 | Standard Specification for Crosslinked and Thermoplastic Extruded Semi-Conducting, Conductor and Insulation Shielding Materials |
| ASTM D 257 : 2014 | Standard Test Methods for DC Resistance or Conductance of Insulating Materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.