ASTM D 3903 : 2015 : REDLINE
Current
The latest, up-to-date edition.
Standard Specification for Rubber Seals Used in Air-Heat Transport of Solar Energy Systems
English
14-08-2015
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 09.02, 2015 Describes the general requirements for the rubber seals used in solar energy systems employing air-heat transport.
| Committee |
D 11
|
| DocumentType |
Redline
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
1.1This specification covers the general requirements for the rubber seals used in solar energy systems employing air-heat transport. Examples are duct and damper seals. Particular applications may necessitate other requirements that would take precedence over these requirements when specified.
Note 1:Rubber seals for the collector are covered in Specifications D3667 and D3771.
1.2Design requirement pertains only to permissible deflections of the rubber during thermal expansion or contraction of the seal in use and the tolerances in dimensions of molded and extruded seals.
1.3This specification does not include requirements pertaining to the fabrication or installation of the seals.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5The following safety hazards caveat pertains only to the test methods portion, Section 10, of this specification: This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 3667 : 2016 : REDLINE | Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors |
| ASTM D 1149 : 2016-02 | TEST METHODS FOR RUBBER DETERIORATION - CRACKING IN AN OZONE CONTROLLED ENVIRONMENT |
| ASTM D 3183 : 201 | PRACTICE FOR RUBBER - PREPARATION OF PIECES FOR TEST PURPOSES FROM PRODUCTS |
| ASTM D 1349 : 2014 : REDLINE | Standard Practice for Rubber—Standard Conditions for Testing |
| ASTM C 661 : 2015 : REDLINE | Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer |
| ASTM D 3182 : 2016 : REDLINE | Standard Practice for Rubber—Materials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets |
| ASTM D 865 : 2011 | Standard Test Method for Rubber<char: emdash>Deterioration by Heating in Air (Test Tube Enclosure) |
| ASTM D 3771 : 2015 : REDLINE | Standard Specification for Rubber Seals Used in Concentrating Solar Collectors |
| ASTM G 7 : 2005 | Standard Practice for Atmospheric Environmental Exposure Testing of Nonmetallic Materials |
| ASTM G 155 : 2013 : REDLINE | Standard Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials |
| ASTM D 1566 : 2015 : REDLINE | TERMINOLOGY RELATING TO RUBBER |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.