ASTM D 3824 : 2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Continuous Measurement of Oxides of Nitrogen in the Ambient or Workplace Atmosphere by the Chemiluminescent Method
Hardcopy , PDF
18-10-2024
English
11-05-2012
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 22
|
| DocumentType |
Test Method
|
| Pages |
12
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 These test methods cover procedures for the continuous determination of total nitrogen dioxide (NO2) and nitric oxide (NO) as NOx, or nitric oxide (NO) alone or nitrogen dioxide (NO2) alone, in the ranges shown in the following table:
| Range of Concentration | ||
| Gas | Ambient Atmosphere | Workplace Atmosphere |
| μg/m3 (ppm) (Note 1) | mg/m3 (ppm) (Note 1) | |
| NO | 10 to 600 (0.01 to 0.5) | 0.6 to 30 (0.5 to 25) |
| (NO + NO2) = NOx | 20 to 1000 (0.01 to 0.05) | 1 to 50 (0.5 to 25) |
| NO2 | 20 to 1000 (0.01 to 0.5) | 1 to 50 (0.5 to 25) |
Note 1—Approximate range: 25°C and 101.3 kPa (1 atm).
1.2 The test methods are based on the chemiluminescent reaction between nitric oxide and ozone.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 9.
| ASTM D 5011 : 2017 | Standard Practices for Calibration of Ozone Monitors Using Transfer Standards |
| ASTM D 4844 : 2016 | Standard Guide for Air Monitoring at Waste Management Facilities for Worker Protection |
| ASTM B 827 : 2005 : R2014 | Standard Practice for Conducting Mixed Flowing Gas (MFG) Environmental Tests |
| ASTM D 3195 : 1990 : R2004 | Standard Practice for Rotameter Calibration |
| ASTM D 1356 : 2015 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 3249 : 1995 : R2011 | Standard Practice for General Ambient Air Analyzer Procedures |
| ASTM D 3249 : 1995 : R2000 | Standard Practice for General Ambient Air Analyzer Procedures |
| ASTM D 1357 : 1995 : R2019 | Standard Practice for Planning the Sampling of the Ambient Atmosphere |
| ASTM D 3609 : 2000 : R2014 | Standard Practice for Calibration Techniques Using Permeation Tubes |
| ASTM D 1357 : 1995 : R2000 | Standard Practice for Planning the Sampling of the Ambient Atmosphere |
| ASTM D 1357 : 1995 : R2005 | Standard Practice for Planning the Sampling of the Ambient Atmosphere |
| ASTM D 1356 : 2017 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 3631 : 1999 : R2004 | Standard Test Methods for Measuring Surface Atmospheric Pressure |
| ASTM D 1356 : 2015 : REV B | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1357 : 1995 : R2011 | Standard Practice for Planning the Sampling of the Ambient Atmosphere |
| ASTM D 3249 : 1995 : R2005 | Standard Practice for General Ambient Air Analyzer Procedures |
| ASTM D 3609 : 2000 : R2005 | Standard Practice for Calibration Techniques Using Permeation Tubes |
| ASTM D 1356 : 2014 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 3631 : 1999 : R2007 | Standard Test Methods for Measuring Surface Atmospheric Pressure |
| ASTM D 3609 : 2000 : R2010 | Standard Practice for Calibration Techniques Using Permeation Tubes |
| ASTM D 3249 : 1995 : R2019 | Standard Practice for General Ambient Air Analyzer Procedures |
| ASTM D 3631 : 1999 : R2011 | Standard Test Methods for Measuring Surface Atmospheric Pressure |
| ASTM D 3609 : 2000 | Standard Practice for Calibration Techniques Using Permeation Tubes |
| ASTM D 1914 : 1995 : R1999 | Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis Atmospheres |
| ASTM D 1356 : 2015 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2005 : R2010 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2020 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1914 : 1995 : R2014 | Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2000 : REV A | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2014 : REV B | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2014 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1914 : 1995 : R2010 | Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1356 : 2005 | Standard Terminology Relating to Sampling and Analysis of Atmospheres |
| ASTM D 1914 : 1995 : R2004 : EDT 1 | Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres |
| ASTM D 3631 : 1999 | Standard Test Methods for Measuring Surface Atmospheric Pressure |
| ASTM D 3631 : 1999 : R2017 | Standard Test Methods for Measuring Surface Atmospheric Pressure |
| ASTM D 3195 : 1990 : R1998 : EDT 1 | Standard Practice for Rotameter Calibration |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.