ASTM D 3737 : 2000 : REV A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Establishing Allowable Properties for Structural Glued Laminated Timber (Glulam)
Hardcopy , PDF
11-11-2014
English
10-11-2001
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 07
|
| DocumentType |
Standard Practice
|
| Pages |
26
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This practice covers the procedures for establishing allowable properties for structural glued laminated timber. Properties considered include bending, tension and compression parallel to the grain, modulus of elasticity, horizontal shear, compression perpendicular to the grain and radial stresses in curved members.
1.2 This practice is limited to the calculation of allowable properties subject to the given procedures for the selection and arrangement of grades of lumber of the species considered.
1.3 Requirements for production, inspection and certification are not included, but in order to justify the allowable properties developed using procedures in this practice, manufacturers must conform to recognized manufacturing standards. Refer to ANSI/AITC AI90.1 and CSA 0122.
1.4 Allowable properties established by use of this practice are based on dry conditions of use (less than 16 % moisture content). Modifications for wet-use conditions are given in 9.2.
1.5 The values stated in inch-pound units are to be regarded as standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 2915 : 2017 | Standard Practice for Sampling and Data-Analysis for Structural Wood and Wood-Based Products |
| ASTM D 198 : 2015 | Standard Test Methods of Static Tests of Lumber in Structural Sizes |
| ASTM D 7341 : 2014 | Standard Practice for Establishing Characteristic Values for Flexural Properties of Structural Glued Laminated Timber by Full-Scale Testing |
| ASTM D 6570 : 2018 : REV A | Standard Practice for Assigning Allowable Properties for Mechanically Graded Lumber |
| ASTM D 7199 : 2007 : R2012 | Standard Practice for Establishing Characteristic Values for Reinforced Glued Laminated Timber (Glulam) Beams Using Mechanics-Based Models |
| ASTM D 5457 : 2019 : REV B | Standard Specification for Computing Reference Resistance of Wood-Based Materials and Structural Connections for Load and Resistance Factor Design |
| ASTM D 7147 : 2011 : R2018 | Standard Specification for Testing and Establishing Allowable Loads of Joist Hangers |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.