ASTM D 2835 : 1989 : R1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements
Hardcopy , PDF
11-11-2014
English
31-12-2010
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.03, 2017 Defines a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement.
| Committee |
D 04
|
| DocumentType |
Standard
|
| Pages |
3
|
| ProductNote |
Reconfirmed 1998 Reconfirmed 2002
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement. For changes to this Standard since the last issue, refer to the Summary of Changes Section at the end of the Standard.
1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency and drying rate.
1.3 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S customary units may be approximate.
| ASTM D 1084 : 2016 : REDLINE | Standard Test Methods for Viscosity of Adhesives |
| ASTM D 907 : 2015 : REDLINE | Standard Terminology of Adhesives |
| ASTM D 638 : 2014 : REDLINE | Standard Test Method for Tensile Properties of Plastics |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.