ASTM D 2275 : 2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Voltage Endurance of Solid Electrical Insulating Materials Subjected to Partial Discharges (Corona) on the Surface
Hardcopy , PDF
28-04-2022
English
11-12-2014
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
D 09
|
| DocumentType |
Test Method
|
| Pages |
9
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method determines the voltage endurance of solid electrical insulating materials for use at commercial power frequencies under the action of corona (see Note 1). This test method is more meaningful for rating materials with respect to their resistance to prolonged ac stress under corona conditions for comparative evaluation between materials.
Note 1:The term “corona” is used almost exclusively in this test method instead of “partial discharge,” because it is a visible glow at the edge of the electrode interface that is the result of partial discharge. Corona, as defined in Terminology D1711, is “visible partial discharges in gases adjacent to a conductor.”
1.2The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
| ASTM D 8065/D8065M : 2016 | Standard Classification System and Basis for Specification for Specifying Plastic Films |
| ASTM D 1868 : 2013 | Standard Test Method for Detection and Measurement of Partial Discharge (Corona) Pulses in Evaluation of Insulation Systems |
| ASTM D 6097 : 2016 | Standard Test Method for Relative Resistance to Vented Water-Tree Growth in Solid Dielectric Insulating Materials |
| ASTM D 5047 : 2017 | Standard Specification for Polyethylene Terephthalate Film and Sheeting |
| ASTM D 3382 : 2013 | Standard Test Methods for Measurement of Energy and Integrated Charge Transfer Due to Partial Discharges (Corona) Using Bridge Techniques |
| ASTM D 1868 : 2013 | Standard Test Method for Detection and Measurement of Partial Discharge (Corona) Pulses in Evaluation of Insulation Systems |
| ASTM D 1711 : 2002 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1868 : 2007 | Standard Test Method for Detection and Measurement of Partial Discharge (Corona) Pulses in Evaluation of Insulation Systems |
| ASTM D 1711 : 2011 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2011 : REV A | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1868 : 1993 : R1998 | Standard Test Method for Detection and Measurement of Partial Discharge (Corona) Pulses in Evaluation of Insulation Systems (Withdrawn 2007) |
| ASTM D 3382 : 2007 | Standard Test Methods for Measurement of Energy and Integrated Charge Transfer Due to Partial Discharges (Corona) Using Bridge Techniques |
| ASTM D 1711 : 2013 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1868 : 2020 | Standard Test Method for Detection and Measurement of Partial Discharge (Corona) Pulses in Evaluation of Insulation Systems |
| ASTM D 1711 : 1999 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 3382 : 1995 | Standard Test Methods for Measurement of Energy and Integrated Charge Transfer Due to Partial Discharges (Corona) Using Bridge Techniques |
| ASTM D 1711 : 2014 : REV A | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2015 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 618 : 2013 | Standard Practice for Conditioning Plastics for Testing |
| ASTM D 1711 : 2014 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2020 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 1711 : 2008 | Standard Terminology Relating to Electrical Insulation |
| ASTM D 618 : 2021 | Standard Practice for Conditioning Plastics for Testing |
| ASTM D 3382 : 2022 | Standard Test Methods for Measurement of Energy and Integrated Charge Transfer Due to Partial Discharges (Corona) Using Bridge Techniques |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.