ASTM C 1471/C1471M : 2005 : R2014 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Guide for the Use of High Solids Content Cold Liquid-Applied Elastomeric Waterproofing Membrane on Vertical Surfaces
Hardcopy , PDF
06-01-2022
English
11-08-2014
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 04.07, 2015 Defines the use of a high solids content, cold liquid-applied elastomeric waterproofing membrane that meets the performance criteria specified in Specification C 836, subject to intermittent hydrostatic pressure in a waterproofing system intended for installation on vertical cast-in-place concrete surfaces.
| Committee |
D 08
|
| DevelopmentNote |
Supersedes ASTM C 1471. (08/2014)
|
| DocumentType |
Guide
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This guide describes the use of a high solids content, cold liquid-applied elastomeric waterproofing membrane that meets the performance criteria specified in Specification C836, subject to intermittent hydrostatic pressure in a waterproofing system intended for installation on vertical cast-in-place concrete surfaces.
1.2The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations.
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM D 7492/D7492M : 2016 : REV A | Standard Guide for Use of Drainage System Media with Waterproofing Systems |
| ASTM C 836/C836M : 2018 | Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course |
| ASTM C 898/C898M : 2009 : R2017 | Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with Separate Wearing Course |
| ASTM C 898 : 2001 | Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane With Separate Wearing Course |
| ASTM D 4263 : 1983 : R2005 | Standard Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method |
| ASTM D 4263 : 1983 : R1999 | Standard Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method |
| ASTM C 117 : 2017 : REDLINE | Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing |
| ASTM D 4263 : 1983 : R2012 | Standard Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method |
| ASTM D 4263 : 1983 : R2018 | Standard Test Method for Indicating Moisture in Concrete by the Plastic Sheet Method |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.