ASTM B 352/B352M : 2017 : REDLINE
Current
The latest, up-to-date edition.
Standard Specification for Zirconium and Zirconium Alloy Sheet, Strip, and Plate for Nuclear Application
English
01-05-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 02.04, 2016 Defines hot- and cold-rolled zirconium and zirconium alloy sheet, strip, and plate.
| Committee |
B 10
|
| DevelopmentNote |
Supersedes ASTM B 352 (08/2002)
|
| DocumentType |
Redline
|
| Pages |
14
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
1.1This specification covers hot- and cold-rolled zirconium and zirconium alloy sheet, strip, and plate.
1.2One unalloyed and three alloys for use in nuclear applications are described.
1.3The products covered in this specification include the following forms and sizes:
1.3.1Sheet, 24 in. [600 mm] or more in width; under 0.187 in. [4.8 mm) in thickness,
1.3.2Strip, less than 24 in. [600 mm] in width; under 0.187 in. [4.8 mm] in thickness, and
1.3.3Plate, over 10 in. [250 mm] in width; 0.187 in. [4.8 mm] and over in thickness.
Note 1:Material over 0.187 in. [4.8 mm] in thickness and less than 10 in. [250 mm] wide is covered as bar in Specification B351/B351M.
1.4Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.
1.5The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM E 1552 : 2015 : REDLINE | Standard Test Method for Determining Hafnium in Zirconium and Zirconium Alloys By Direct Current Plasma—Atomic Emission Spectrometry |
| N285.0-17/N285.6 SERIES-17 | General requirements for pressure-retaining systems and components in CANDU nuclear power plants / Material Standards for reactor components for CANDU nuclear power plants |
| CSA N285.6 SERIES : 2005 | MATERIAL STANDARDS FOR REACTOR COMPONENTS FOR CANDU NUCLEAR POWER PLANTS |
| ASTM E 114 : 2015 : REDLINE | Standard Practice for Ultrasonic Pulse-Echo Straight-Beam Contact Testing |
| ASTM E 8/E8M : 2016-09 | TEST METHODS FOR TENSION TESTING OF METALLIC MATERIALS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.