ANSI/AWWA D107-16 ERR 1(CSV)
Current
The latest, up-to-date edition.
COMPOSITE ELEVATED TANKS FOR WATER STORAGE
Hardcopy , PDF
English
01-01-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
I Introduction
II Special Issues
III Use of This Standard
IV Major Revisions
V Comments
Standard
1 General
2 References
3 Definitions
4 General Requirements for Analysis and Design
5 Steel Tank
6 Concrete Support Structure
7 Foundations
8 Accessories
9 Inspection and Testing
Appendixes
A Commentary on Selected Sections
of the Standard
B Information Provided by Purchaser
C Recommendations for Geotechnical
Investigation
Specifies the design, construction, inspection, and testing of composite elevated tanks that use a welded steel tank for watertight containment and a single pedestal concrete support structure.
| DocumentType |
Revision
|
| ISBN |
9781625761873
|
| Pages |
136
|
| PublisherName |
American Water Works Association
|
| Status |
Current
|
| Supersedes |
| AWWA M42 : 2013 | STEEL WATER-STORAGE TANKS |
| ACI 371R : 2016 | GUIDE FOR THE ANALYSIS, DESIGN, AND CONSTRUCTION OF ELEVATED CONCRETE AND COMPOSITE STEEL-CONCRETE WATER STORAGE TANKS |
| NFPA 22 : 2018 | WATER TANKS FOR PRIVATE FIRE PROTECTION |
| AWS A2.4 : 2012 | STANDARD SYMBOLS FOR WELDING, BRAZING, AND NONDESTRUCTIVE EXAMINATION |
| ASNT SNT TC 1A : 2016 | TOPICAL OUTLINES FOR QUALIFICATION OF NONDESTRUCTIVE TESTING PERSONNEL |
| AWWA C205 : 2012 | CEMENT-MORTAR PROTECTIVE LINING AND COATING FOR STEEL WATER PIPE - 4 IN. (100 MM) AND LARGER - SHOP APPLIED |
| ASTM A 435/A435M : 2017 : REDLINE | Standard Specification for Straight-Beam Ultrasonic Examination of Steel Plates |
| ASTM A 123/A123M : 2017 : REDLINE | Standard Specification for Zinc (Hot-Dip Galvanized) Coatings on Iron and Steel Products |
| ASME PV CODE 9 : 2017 | BOILER AND PRESSURE VESSEL CODE - WELDING, BRAZING, AND FUSING QUALIFICATIONS - QUALIFICATION STANDARD FOR WELDING, BRAZING, AND FUSING PROCEDURES; WELDERS; BRAZERS; AND WELDING, BRAZING, AND FUSING OPERATORS |
| ASTM A 537/A537M : 2013 | Standard Specification for Pressure Vessel Plates, Heat-Treated, Carbon-Manganese-Silicon Steel |
| NFPA 780 : 2017 | INSTALLATION OF LIGHTNING PROTECTION SYSTEMS |
| CFR 29(PTS1900-1910) : 0 | LABOR - OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR |
| ASTM D 2435/D2435M : 2011 : REDLINE | Standard Test Methods for One-Dimensional Consolidation Properties of Soils Using Incremental Loading |
| ACI 318 : 2014 | BUILDING CODE REQUIREMENTS FOR STRUCTURAL CONCRETE AND COMMENTARY |
| ASME PV CODE 8 DIV 1 : 2017 | BOILER AND PRESSURE VESSEL CODE - RULES FOR CONSTRUCTION OF PRESSURE VESSELS DIVISION 1 |
| ANSI/AWWA C200 : 2017 | STEEL WATER PIPE, 6 IN. (150 MM) AND LARGER |
| AWWA C220 : 2017 | STAINLESS-STEEL PIPE, 1/2 IN. (13 MM) AND LARGER |
| ASTM A 516/A516M : 2017 : REDLINE | Standard Specification for Pressure Vessel Plates, Carbon Steel, for Moderate- and Lower-Temperature Service |
| NEMA 250 : 2014 | ENCLOSURES FOR ELECTRICAL EQUIPMENT (1000 VOLTS MAXIMUM) |
| ANSI/AWWA C213 : 2015 | FUSION-BONDED EPOXY COATINGS AND LININGS FOR STEEL WATER PIPE AND FITTINGS |
| ASTM D 698 : 2013-05 | TEST METHODS FOR LABORATORY COMPACTION CHARACTERISTICS OF SOIL USING STANDARD EFFORT (12400 FT-LBF/FT[3] (600 KN-M/M[3])) |
| ASTM C 1077 : 2017 : REDLINE | Standard Practice for Agencies Testing Concrete and Concrete Aggregates for Use in Construction and Criteria for Testing Agency Evaluation |
| AISC 360 : 2016 | SPECIFICATION FOR STRUCTURAL STEEL BUILDINGS |
| AWS D1.4/D1.4M : 2011 | STRUCTURAL WELDING CODE - REINFORCING STEEL |
| ASTM C 309 : 2011 : REDLINE | Standard Specification for Liquid Membrane-Forming Compounds for Curing Concrete |
| AWS B2.1 : 2005 | SPECIFICATION FOR WELDING PROCEDURE AND PERFORMANCE QUALIFICATION |
| ASCE 7 10 : 2010 | MINIMUM DESIGN LOADS FOR BUILDINGS AND OTHER STRUCTURES |
| ASTM D 1143 : 2007 | TEST METHOD FOR PILES UNDER STATIC AXIAL COMPRESSIVE LOAD |
| AWS QC1 : 2007 | STANDARD FOR AWS CERTIFICATION OF WELDING INSPECTORS |
| ASTM C 597 : 2016 : REDLINE | Standard Test Method for Pulse Velocity Through Concrete |
| W178.2-14 | Certification of welding inspectors |
| ANSI/AWWA C652 : 2011 | DISINFECTION OF WATER-STORAGE FACILITIES |
| NFPA 70 : 2017 | NATIONAL ELECTRICAL CODE |
| AWWA D102 : 2014 | COATING STEEL WATER-STORAGE TANKS |
| ASME PV CODE 5 : 2017 | BOILER AND PRESSURE VESSEL CODE - NONDESTRUCTIVE EXAMINATION |
| AWWA D100 : 2011 | WELDED CARBON STEEL TANKS FOR WATER STORAGE |
| ASTM C 805 : 2002 | Standard Test Method for Rebound Number of Hardened Concrete |
| AWS D1.1/D1.1M : 2015 | STRUCTURAL WELDING CODE-STEEL |
| ASTM D 1587/D1587M : 2015 : REDLINE | Standard Practice for Thin-Walled Tube Sampling of Fine-Grained Soils for Geotechnical Purposes |
| ACI 306.1 : 1990 | STANDARD SPECIFICATION FOR COLD WEATHER CONCRETING |
| AWWA C210 : 2015 | LIQUID-EPOXY COATINGS AND LININGS FOR STEEL WATER PIPE AND FITTINGS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.