A-A-59812 Revision A:2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Holder, Electrical Card, Metal Card Guide, Multiple Piece, General Requirements for
English
26-11-2015
27-10-2020
1. SCOPE
2. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN)
3. SALIENT CHARACTERISTICS
4. REGULATORY REQUIREMENTS
5. PRODUCT CONFORMANCE PROVISIONS
6. PACKAGING
7. NOTES
Specifies the general requirements for a family of metal card guides (hereafter referred to as card guides) intended for use to guide and hold circuit card assemblies into their installed positions.
| DocumentType |
Standard
|
| Pages |
6
|
| PublisherName |
US Military Specs/Standards/Handbooks
|
| Status |
Superseded
|
| SupersededBy |
This commercial item description (CID) covers the general requirements for a family of metal card guides (hereafter referred to as card guides) intended for use to guide and hold circuit card assemblies into their installed positions. Card guides covered by this CID are for moderate heat transfer and vibration applications. Requirements for specific card guides are covered in the individual CID specification sheets. Card guides covered by this CID are intended for commercial/industrial applications.
| A-A-59812-2 Revision A:2015 | Holder, Electrical Card, Metal Card Guide, Center Mounting, with Multiple Mounting Holes and Heat Transfer Housing, for Chassis or Cold Plate Mounting Applications |
| A-A-59812-1 Revision A:2015 | Holder, Electrical Card, Metal Card Guide, Multiple Piece, Center Mounting, with 2,3, or 4 Mounting Holes and Support Housing for Chassis or Cold Plate Mounting Applications |
| A-A-59812-4 Revision A:2015 | Holder, Electrical Card, Metal Card Guide, Multiple Piece, Flange Mounting with Two, Three, or Four Mounting Holes for Chassis or Cold Plate Mounting Applications |
| A-A-59812-3 Revision A:2015 | Holder, Electrical Card, Metal Card Guide, Multiple Piece, with Heat Transfer Housing, Flange Mounting with Two, Three, or Four Mounting Holes for Chassis or Cold Plate Mounting Applications |
| MIL-HDBK-1861 Revision B:2013 | Selection and Use1 of Electrical and Electronic Assemblies, Boards, Cards, and Associated Hardware |
| SAE AMSQQA200/8A | Aluminum Alloy 6061, Bar, Rod, Shapes, Tube, and Wire, Extruded A96061 |
| ASTM B 221 : 2014 : REDLINE | Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes |
| MIL-DTL-5541 Revision F:2006 | Chemical Conversion Coatings on Aluminum and Aluminum Alloys |
| ASTM B 103/B103M : 2015 : REDLINE | Standard Specification for Phosphor Bronze Plate, Sheet, Strip, and Rolled Bar |
| MIL A 8625 : F | ANODIC COATINGS FOR ALUMINUM AND ALUMINUM ALLOYS |
| ASTM B 194 : 2015 : REDLINE | Standard Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.