UNE-EN 1453-1:2017

This part of EN 1453 specifies the requirements for structured-wall unplasticized poly(vinyl chloride) (PVC U) pipes and the system intended to be used for soil and waste discharge applications (low and high temperature) inside buildings (application area code "B")NOTE 1The intended use is reflected in the marking of products by "B".This part of EN 1453 is also applicable to structured-wall unplasticized poly(vinyl chloride) (PVC U) pipes, and the system intended for the following purposes:¾ðventilating part of the pipework in association with discharge applications¾ðrainwater pipework inside building.It also specifies the test parameters for the test methods referred to in this standard.NOTE 2Fully foamed PVC-U pipes and spirally-formed PVC U pipes are not covered by this standard.This standard covers a range of nominal sizes and gives recommendations concerning colours.NOTE 3It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.For external above ground application additional requirements depending on the climate should be agreed between the manufacturer and the user.NOTE 4Pipes conforming to this standard are normally associated with fittings conforming to EN 1329 1. Pipes, fittings and components conforming to any of the product standards listed in Annex C can also be used with pipes conforming to this standard, provided they conform to the requirements for joint dimensions given in Clause 6 and to the requirements in Table 10.NOTE 5Joints and adhesives are considered to be part of the system as covered in the scope.