UNI EN 14035-27 : 2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Construction
   4.1 Means of ignition
   4.2 Attachment of initial fuse
   4.3 Protection of initial fuse
   4.4 Materials of firework case
   4.5 Integrity
   4.6 Net explosive content
   4.7 Mass of report and/or bursting charge
   4.8 Means of stabilization of flight
   4.9 Vertical stability
5 Performance
   5.1 Initial fuse
   5.2 Principle effect
   5.3 Height of explosions and bursting
   5.4 Functioning
   5.5 Stabilization of flight
   5.6 Burning matter
   5.7 Debris
   5.8 Angle of flight
   5.9 Rocket motor
6 Primary pack or selection pack
7 Minimum labelling requirements
   7.1 General
   7.2 Type name and category
   7.3 Safety information
   7.4 Name and address and telephone number of manufacturer
       or distributor or importer
   7.5 Reference to this standard
   7.6 Printing
   7.7 Marking of very small rockets
   7.8 Additional information on the primary pack
       (if applicable)
8 Test methods
   8.1 Attachment of protruding fuse (type test and batch test)
   8.2 Vertical stability (type test)
   8.3 Performance (type test and batch test)
   8.4 Determination of net explosive content and mass of report
       and/or bursting charge (type test)
   8.5 Side ignition of initial fuse (type test)
   8.6 Labelling (type test and batch test)
Annex A (normative) Type testing
Annex B (normative) Batch testing
Annex C (normative) Method for determination of smouldering
                    rate of cigarette
Annex D (informative) A-Deviations

Gives requirements for the construction, performance, primary packaging and labelling of rockets and the corresponding test methods. Applies to fireworks which are classified as rockets in categories 2 and 3 in EN 14035-2.