UNI EN 1254-6 : 2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Testing, assessment and sampling methods
6 Evaluation of conformity
7 Classification and designation
8 Marking
9 Documentation
Annex A (normative) - Method for testing leaktightness
        of joints under internal hydrostatic pressure
Annex B (normative) - Method for testing resistance
        to pull-out of joints with metallic tube
Annex C (normative) - Test method for resistance of
        joints with metallic tube to temperature cycling
Annex D (normative) - Method for testing the resistance
        of joints with metallic tube to pressure cycling
Annex E (normative) - Test method for leaktightness of
        joints with metallic tube under vacuum
Annex F (normative) - Test method for the resistance of
        joints with metallic tube to vibration
Annex G (normative) - Test method for leaktightness of
        joints with metallic tube under internal
        hydrostatic pressure while subjected to bending
Annex H (normative) - Test method for disconnection
        and re-use
Annex I (normative) - Fitting rotation test
Annex J (normative) - Determination of resistance to
        stress corrosion
Annex K (normative) - Pressure test for fittings bodies
        with as-cast microstructure or fabricated by
        welding or brazing
Annex L (normative) - Determination of mean depth of
        dezincification
Bibliography

Defines push-fit end connections with or without plating or coating in the size range 6 mm to 54 mm for the purpose of joining tubes of copper, plated copper, multilayer pipes and plastics pipes, intended for use in hot and cold water systems according to EN 806.