UNE-EN 10080:2006

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Designation
   5.1 Bar, coil and de-coiled product
   5.2 Welded fabric
   5.3 Lattice girders
6 Steelmaking and manufacturing processes
7 Performance characteristics
   7.1 Weldability and chemical composition
   7.2 Mechanical properties
   7.3 Dimensions, mass and tolerances
   7.4 Bond strength and surface geometry
   7.5 Verification of performance characteristics
8 Evaluation of conformity
   8.1 Factory production control
   8.2 Initial type testing
   8.3 Continuous surveillance of factory production
        control and audit testing
   8.4 Evaluation, reporting and action
   8.5 Assessment of the long term quality level
9 Test methods
   9.1 Bars, coils and de-coiled products
   9.2 Welded fabric
   9.3 Lattice girders
10 Identification of the manufacturer and the technical
   class
   10.1 Bar
   10.2 Coil
   10.3 De-coiled product
   10.4 Welded fabric
   10.5 Lattice girders
11 Verification of mechanical properties in the case of
   dispute
Annex A (informative) Examples of weld points in lattice
         girder joints
Annex B (normative) Test methods for lattice girders
Annex C (informative) Bond test for ribbed and indented
         reinforcing steel-Beam test
Annex D (informative) Bond test for ribbed and indented
         reinforcing steel - Pull-out test
Annex E (informative) Comparison of symbols used in this
         European Standard with those used in EN 1992-1-1
         and EN 1992-1-2
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive
Bibliography

Describes the requirements and definitions for the performance characteristics of weldable reinforcing steel used for the reinforcement of concrete structures and delivered as finished products.