SN EN 60317-0-1 : 1998 AMD 2 2005

Foreword
Introduction
1 Scope
2 Normative references
3 Definitions and general notes on methods of test
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation (nominal conductor diameters up
   to and including 1,600 mm)
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
30 Packaging
Annex A (informative) Dimensions for intermediate nominal
                      conductor diameters (R 40)
Annex B (informative) Method for the calculation of minimum
                      overall diameter
Annex C (informative) Method for the calculation of linear
                      resistance
Annex D (informative) Resistance
Annex E (informative) High temperature failure test
Annex ZA (normative) Normative references to international
                      publications with their corresponding
                      European publications

Specifies the general requirements of enameled round copper winding wires with or without a bonding layer.