SN EN 15014 : 2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Performance requirements
  4.1 Reaction to fire for applications inside building
  4.2 External pressure strength
  4.3 Internal pressure strength
  4.4 Dimensional tolerances
  4.5 Tightness (air and liquid)
  4.6 Durability
  4.7 Dangerous substances
5 Test methods
  5.1 Reaction to fire for applications inside building
  5.2 Determination of the nominal pressure
  5.3 Internal pressure strength
  5.4 Dimensional tolerances
  5.5 Tightness
  5.6 Durability
6 Evaluation of conformity
  6.1 General
  6.2 Initial type testing
  6.3 Factory production control
  6.4 One-off products and products produced in very low quantities
Annex A (normative) Product standards for buried and above-ground
        pressure piping systems in plastics materials for water
        for general purposes, drainage, sewerage, irrigation and
        other fluids
Annex B (normative) Standards for assessment of conformity for
        buried and above-ground pressure piping systems in
        plastics materials for water for general purposes,
        drainage, sewerage, irrigation and other fluids
Annex ZA (informative) Clauses of this European Standard addressing
         the provisions of EU Construction Products Directive
  ZA.1 Scope and relevant characteristics
  ZA.2 Procedure for attestation of conformity of plastics pipes
       and fittings
       ZA.2.1 Systems of attestation of conformity
       ZA.2.2 EC Certificate and Declaration of conformity
  ZA.3 CE marking and labelling
       ZA.3.1 CE marking requirements
       ZA.3.2 Simplified CE marking with reference to a web site
              ZA.3.2.1 General
              ZA.3.2.2 Minimum rules for the proper use of a web
                       site for CE marking information
National Annex NA (informative) Product standards used in
                                conjunction with this standard
Bibliography

Describes performance requirements for plastics pipes, fittings and their joints for buried or above-ground pressure applications for water for general purposes, drainage, sewerage and irrigation, as well as for any other pressure application with other fluids covered by the Construction Products Directive with the exception of drinking water distribution for human consumption.