SAE J 1699-1 : 2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SAE J1850 VERIFICATION TEST PROCEDURES
Hardcopy , PDF
31-05-2023
English
05-06-2006
1 Scope
1.1 Purpose
1.2 Application
2 References
2.1 Applicable Documents
2.1.1 SAE Publications
2.2 Related Publication
2.2.1 SAE Publications
3 Definitions
4 Abbreviations and Acronyms
5 General Information
5.1 Test Procedure Overview
5.1.1 Invalid CRC Test
5.1.2 Message Structure Test
5.1.3 Bus Arbitration Test
5.1.4 Bus Fault Test
5.1.5 Symbol Parameter Limits
5.2 Generic Test Conditions
5.2.1 Digital Scope Requirements
5.2.2 Power Supply Requirements
5.2.3 Digital Volt Ohm Meter (DVOM)
Requirements
5.2.4 Ground Offset Voltage Device
5.2.5 Small Signal Ground Offset Voltage Device
5.2.6 VPW Bus RX/TX Circuit
5.2.7 PWM Bus RX/TX Circuit
5.2.8 PWM Scope Input Filter
5.2.9 Network Access Device Requirements (NAD)
5.2.10 Network Load Device for PWM and VPW
Describes test methods, test procedures, and specific test parameters to help verify that vehicles and test tools can communicate using the SAE J1850. Also verifies the portion of SAE J1850 that is used for OBD-II communications.
| DocumentType |
Test Method
|
| Pages |
27
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy |
| SAE J 1699-4 : 2014 | OBD-2 COMMUNICATIONS ANOMALY LIST |
| SAE J 1699/2 : 2017 | TEST CASES FOR OBD-2 SCAN TOOLS AND I/M TEST EQUIPMENT |
| SAE J 1699/3 : 2017 | VEHICLE OBD 2 COMPLIANCE TEST CASES |
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.