PD CEN/TS 14632:2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviated terms
5 General
6 Testing and inspection
Annex A (normative) - Procedures for dealing
        with test data provided by the manufacturer
        and for witnessed tests in a manufacturer's
        laboratory
Annex B (normative) - Definitions of changes in
        material, design and process
Annex C (normative) - Tests to assess the effects
        of changes
Annex D (normative) - Parameters and criteria for
        reduced long-term tests (RLTT)
Annex E (normative) - Parameters and criteria for
        dry creep and alpha and beta testing
Annex F (normative) - Additional statements for
        manholes and inspection chambers
Bibliography

Provides guidance on the assessment of conformity of GRP-UP (glass-reinforced thermosetting resins based on unsaturated polyesters) piping products and assemblies in accordance with EN 1796 and EN 14364 intended to be included in the manufacturer's quality plan as part of the quality management system and for the establishment of third-party certification procedures.

This Technical Specification gives guidance on the assessment of conformity of GRP-UP (glass-reinforced thermosetting resins based on unsaturated polyesters) piping products and assemblies in accordance with EN 1796 and EN 14364 intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of third-party certification procedures.

This Technical Specification also gives guidance on the assessment of conformity of GRP-UP manholes and inspection chambers in accordance with prEN 15383. Pipes according to EN 14364 are used for manufacturing the shafts and chamber units. Additional statements as needed to assess the conformity of manholes and inspection chambers are given in Annex F.

NOTE 1 It is recommended that the quality management system conforms to or is no less stringent than the relevant requirements to EN ISO 9001 [3].

NOTE 2 If third-party certification is involved, it is recommended that the certification body is accredited to EN 45011 [1], EN 45012 [2] or EN ISO/IEC 17021 [5], as applicable.