NFPA 8506 : 1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
HEAT RECOVERY STEAM GENERATOR SYSTEMS
Hardcopy
English
01-01-1998
09-02-2001
Foreword
Chapter 1 Introduction
1-1 Scope
1-2 Purpose
Chapter 2 General
2-1 HRSG Fires and explosions
2-2 HRSG Implosions
2-3 Manufacture, design and engineering
2-4 Basic operating objectives
Chapter 3 Definitions
3-1 Definitions
Chapter 4 Project coordination
4-1 General
4-2 Project inception
4-3 Design
4-4 Construction and installation
4-5 Initial training
4-6 Commissioning
Chapter 5 Equipment
5-1 General
5-2 Combustion turbine
5-3 HRSG Fuel-burning system
5-4 HRSG Enclosure
5-5 Selective catalytic reduction
5-6 Electrical
Chapter 6 Controls, monitoring, alarms and interlocks
6-1 Control functions
6-2 Monitoring
6-3 Alarms
6-4 Interlocks
6-5 Burner management system logic
6-6 Operator interface
Chapter 7 Purge, statup, operation and shutdown
of HRSG systems
7-1 General
7-2 General operating requirements
7-3 Cold start preparation
7-4 Combustion turbine purge and light-off
7-5 Duct burner purge and light-off
7-6 Normal operation
7-7 Normal shutdown
7-8 Normal hot restart
7-9 Duct burner emergency shutdown
Chapter 8 Inspection, maintenance, training and safety
8-1 Equipment inspection and maintenance
8-2 Training
Chapter 9 Combustion turbine exhaust bypass systems
for unfired HRSGs
9-1 General
9-2 Purge
9-3 Damper requirements
Chapter 10 Fully fired systems
Chapter 11 Referenced publications
Appendix A Explanatory material
Appendix B Industry experience
Appendix C Gas bypass and alternate burner systems
Appendix D Referenced publications
Appendix E Additional references
Index
Establishes requirements for steam generators that recover heat from a combustion turbine.
| DocumentType |
Standard
|
| Pages |
44
|
| PublisherName |
National Fire Protection Association
|
| Status |
Superseded
|
| SupersededBy |
| NFPA 31 : 2016 | INSTALLATION OF OIL-BURNING EQUIPMENT |
| ASME B31.1 : 2016 | POWER PIPING |
| NFPA 850 : 2015 | FIRE PROTECTION FOR ELECTRIC GENERATING PLANTS AND HIGH VOLTAGE DIRECT CURRENT CONVERTER STATIONS |
| MIL T 5624 : R | TURBINE FUEL, AVIATION, GRADES JP 4 AND JP 5 |
| NFPA 69 : 2014 | EXPLOSION PREVENTION SYSTEMS |
| ANSI K61.1 : 1999 | SAFETY REQUIREMENTS FOR THE STORAGE AND HANDLING OF ANHYDROUS AMMONIA |
| CGA G 2 : 1995 | ANHYDROUS AMMONIA |
| NFPA 8501 : 1997 | SINGLE BURNER BOILER OPERATION |
| NFPA 70 : 2017 | NATIONAL ELECTRICAL CODE |
| CFR 29(PT1910.1000 TO END) : 0 | LABOR - OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR |
| NFPA 499 : 2017 | CLASSIFICATION OF COMBUSTIBLE DUSTS AND OF HAZARDOUS (CLASSIFIED) LOCATIONS FOR ELECTRICAL INSTALLATIONS IN CHEMICAL PROCESS AREAS |
| NFPA 77 : 2014 | STATIC ELECTRICITY |
| NFPA 8502 : 1999 | PREVENTION OF FURNACE EXPLOSIONS/IMPLOSIONS IN MULTIPLE BURNER BOILERS |
| NFPA 54 : 2018 | NATIONAL FUEL GAS CODE |
| NFPA 497 : 2017 | CLASSIFICATION OF FLAMMABLE LIQUIDS, GASES, OR VAPORS AND OF HAZARDOUS (CLASSIFIED) LOCATIONS FOR ELECTRICAL INSTALLATIONS IN CHEMICAL PROCESS AREAS |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.