I.S. EN 61747-5:1999

FOREWORD
1 General
  1.1 Scope and object
  1.2 Normative references
  1.3 Terms, definitions and letter symbols
  1.4 Standard atmospheric conditions
  1.5 Visual examination and verification of dimensions
  1.6 Electrical and optical measurements
  1.7 Electrical operating conditions
2 Mechanical test methods
  2.1 Robustness of terminations
  2.2 Soldering
  2.3 Vibration (sinusoidal)
  2.4 Shock
  2.5 Acceleration, steady state
  2.6 Bond strength test
3 Environmental and endurance test methods
  3.1 Change of temperature
  3.2 Storage (at high temperature)
  3.3 Storage (at low temperature)
  3.4 Low air pressure
  3.5 Damp heat, steady state
  3.6 Damp heat, cyclic (12+12-hour cycle)
  3.7 Composite temperature/humidity cyclic test support
  3.8 Light exposure
  3.9 ESD Test
4 Miscellaneous test methods
  4.1 Permanence of marking
  4.2 Scratch test (of face plate)
  4.3 Life test
5 Visual inspection of monochrome matrix liquid crystal
  display modules (Excluding all active matrix liquid crystal
  display modules)
  5.1 General
  5.2 Visual inspection of displays
6 Visual inspection of monochrome liquid crystal display cells
  (Excluding all active matrix liquid crystal display modules)
  6.1 General
  6.2 Visual inspection of displays
  6.3 Seal inspections
  6.4 Visual inspection of contact pad area
  6.5 Visual inspection for chipped material at the borders and
      edges of the plates of cells
Annex A (informative) - Cross references index
Annex ZA (normative) Normative references to international
                        publications with their corresponding
                        European publications

Gives test methods applicable to liquid crystal display devices.