I.S. EN 60706-2:2006

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and acronyms
  3.1 Terms and definitions
  3.2 Acronyms
4 General approach
5 Principle of maintainability
6 Maintainability activities in the life cycle
  6.1 General
  6.2 Concept and definition phase
  6.3 Design and development phase
  6.4 Manufacture and installation phase
  6.5 Operation and maintenance phases
  6.6 Disposal phase
7 Specification of maintainability requirements
  7.1 Statement of maintainability requirements
  7.2 Maintainability characteristics
  7.3 Constraints
  7.4 Maintainability programme requirements
  7.5 Verification
8 Maintainability studies in the design and development phase
  8.1 General
  8.2 Objectives
  8.3 Maintainability studies in the design process
  8.4 Analysis tools and procedures
9 Design support
  9.1 Liaison
  9.2 Design criteria and check-lists
  9.3 Design reviews
Annex A (informative) Maintainability allocation
Annex B (informative) Example of a maintainability allocation
Annex C (informative) Example of allocation of reliability
        values and maintenance strategy selection for a system
        with non-constant failure rate
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography

Covers the maintainability requirements and related design and use parameter, and discusses some activities necessary to achieve the required maintainability characteristics and their relationship to planning of maintenance. It describes the general approach in reaching these objectives and shows how maintainability characteristics should be specified in a requirements document or contract.