Customer Support: 131 242

  • Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

I.S. EN 60601-2-51:2003

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

MEDICAL ELECTRICAL EQUIPMENT - PART 2-51: PARTICULAR REQUIREMENTS FOR SAFETY, INCLUDING ESSENTIAL PERFORMANCE, OF RECORDING AND ANALYSING SINGLE CHANNEL AND MULTICHANNEL ELECTROCARDIOGRAPHS

Available format(s)

Hardcopy , PDF

Superseded date

10-11-2015

Superseded by

I.S. EN 60601-2-25:2015

Language(s)

English

Published date

01-01-2003

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

$237.15
Including GST where applicable

FOREWORD
INTRODUCTION
SECTION ONE - GENERAL
1 Scope and object
2 Terminology and definitions
4 General requirements for tests
6 Identification, marking and documents
SECTION TWO - ENVIRONMENTAL CONDITIONS
SECTION THREE - PROTECTION AGAINST ELECTRIC SHOCK HAZARDS
SECTION FOUR - PROTECTION AGAINST MECHANICAL HAZARDS
SECTION FIVE - PROTECTION AGAINST HAZARDS FROM UNWANTED
               OR EXCESSIVE RADIATION
SECTION SIX - PROTECTION AGAINST HAZARDS OF IGNITION OF
              FLAMMABLE ANAESTHETIC MIXTURES
SECTION SEVEN - PROTECTION AGAINST EXCESSIVE TEMPERATURES
                AND OTHER SAFETY HAZARDS
SECTION EIGHT - ACCURACY OF OPERATING DATA AND PROTECTION
                AGAINST HAZARDOUS OUTPUT
50 Accuracy of operating data
   50.101 Automated measurements on ECGs (for ANALYSING
          ELECTROCARDIOGRAPHS)
   50.102 Automated ECG interpretation (for ANALYSING
          ELECTROCARDIOGRAPHS)
51 Protection against hazardous output
   51.101 LEADS
   51.102 Input circuit
   51.103 CALIBRATION
   51.104 SENSITIVITY
   51.105 Reduction of the effects of unwanted external
          voltages
   51.106 Base-line
   51.107 Distortion
   51.108 Printing, electronic storage and transmission
   51.109 Use with cardiac pacemakers
SECTION NINE - ABNORMAL OPERATION AND FAULT CONDITIONS;
               ENVIRONMENTAL TESTS
SECTION TEN - CONSTRUCTIONAL REQUIREMENTS
56 Components and general assembly
   56.7 BATTERIES
Appendix L (normative) References - Publications
           mentioned in this standard
Annex AA (informative) General guidance and rationale
Annex BB (informative) ELECTRODES, their positions,
         identifications and colour codes
Annex CC (informative) LEADS and their identification
Annex DD (informative) Polarity of PATIENT LEADS
Annex EE (informative) Additional marking of electrodes
Annex FF (informative) Noise
Annex GG (normative) Definitions and rules for the
         measurement of ELECTROCARDIOGRAMS
Annex HH (normative) Calibration and test data sets
Annex II (informative) CTS test atlas
Bibliography
INDEX OF DEFINED TERMS

Describes particular requirements, in addition to the requirements of EN 60601-2-25, for the safety, including essential performance of recording and analysing single channel and multichannel electrocardiographs.

DocumentType
Standard
Pages
96
PublisherName
National Standards Authority of Ireland
Status
Superseded
SupersededBy

AAMI EC11 : 1991 DIAGNOSTIC ELECTROCARDIOGRAPHIC DEVICES
IEC 60601-1:2005+AMD1:2012 CSV Medical electrical equipment - Part 1: General requirements for basic safety and essential performance
EN 60601-2-25:2015 Medical electrical equipment - Part 2-25: Particular requirements for the basic safety and essential performance of electrocardiographs
ENV 1064 : 1994 MEDICAL INFORMATICS - STANDARD COMMUNICATION PROTOCOL - COMPUTER ASSISTED ELECTROCARDIOGRAPHY
IEC 60601-2-25:2011 Medical electrical equipment - Part 2-25: Particular requirements for the basic safety and essential performance of electrocardiographs
EN 60601-1-4:1996/A1:1999 MEDICAL ELECTRICAL EQUIPMENT - GENERAL REQUIREMENTS FOR SAFETY - COLLATERAL STANDARD: PROGRAMMABLE ELECTRICAL MEDICAL SYSTEMS
IEC 60601-1-4:1996+AMD1:1999 CSV Medical electrical equipment - Part 1-4: General requirements for safety - Collateral Standard: Programmable electrical medical systems

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.