I.S. EN 14058:2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PROTECTIVE CLOTHING - GARMENTS FOR PROTECTION AGAINST COOL ENVIRONMENTS
Hardcopy , PDF
04-05-2023
English
01-01-2017
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
National Foreword
European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Performance assessment and requirements
5 Pre-treatment
6 Test methods
7 Size designation
8 Marking and care labeling
9 Information supplied by the manufacturer
Annex A (informative) - Significant changes between
this document and the previous edition
Annex B (normative) - Standard ensemble R for the
testing of protective garments against cool
environments
Annex C (informative) - Temperature ranges of utility
Annex ZA (informative) - Relationship between this
European Standard and the essential requirements
of EU Directive 89/686/EEC aimed to be covered
Annex ZB (informative) - Relationship between this
European Standard and the essential requirements
of Regulation (EU) 2016/425 of the European
Parliament and of the Council of 9 March 2016 on
personal protective equipment aimed to be covered
Bibliography
Defines requirements and test methods for the performance of garments for protection against the effects of cool environments above -5 Degree C.
| DocumentType |
Standard
|
| Pages |
28
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| UNE-EN 14058:2004 | Identical |
| NBN EN 14058 : 2004 | Identical |
| BS EN 14058:2004 | Identical |
| EN 14058:2017 | Identical |
| UNI EN 14058 : 2004 | Identical |
| EN 20811:1992 | Textiles - Determination of resistance to water penetration - Hydrostatic pressure test |
| ISO 6330:2012 | Textiles Domestic washing and drying procedures for textile testing |
| ISO 9237:1995 | Textiles — Determination of the permeability of fabrics to air |
| ISO 15831:2004 | Clothing — Physiological effects — Measurement of thermal insulation by means of a thermal manikin |
| ISO 13688:2013 | Protective clothing — General requirements |
| EN ISO 9237:1995 | Textiles - Determination of permeability of fabrics to air (ISO 9237:1995) |
| EN ISO 13938-2:1999 | Textiles - Bursting properties of fabrics - Part 2: Pneumatic method for determination of bursting strength and bursting distension (ISO 13938-2:1999) |
| ISO 13938-2:1999 | Textiles Bursting properties of fabrics Part 2: Pneumatic method for determination of bursting strength and bursting distension |
| ISO 30023:2010 | Textiles Qualification symbols for labelling workwear to be industrially laundered |
| EN ISO 11079:2007 | Ergonomics of the thermal environment - Determination and interpretation of cold stress when using required clothing insulation (IREQ) and local cooling effects (ISO 11079:2007) |
| EN ISO 5077:2008 | Textiles - Determination of dimensional change in washing and drying (ISO 5077:2007) |
| ISO 11079:2007 | Ergonomics of the thermal environment Determination and interpretation of cold stress when using required clothing insulation (IREQ) and local cooling effects |
| EN ISO 4674-1:2016 | Rubber- or plastics-coated fabrics - Determination of tear resistance - Part 1: Constant rate of tear methods (ISO 4674-1:2016) |
| EN ISO 30023:2012 | Textiles - Qualification symbols for labelling workwear to be industrially laundered (ISO 30023:2010) |
| EN ISO 13938-1:1999 | Textiles - Bursting properties of fabrics - Part 1: Hydraulic method for determination of bursting strength and bursting distension (ISO 13938-1:1999) |
| ISO 11092:2014 | Textiles — Physiological effects — Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test) |
| EN 511:2006 | Protective gloves against cold |
| EN ISO 11092:2014 | Textiles - Physiological effects - Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test) (ISO 11092:2014) |
| EN ISO 13688:2013 | Protective clothing - General requirements (ISO 13688:2013) |
| ISO 15797:2002 | Textiles Industrial washing and finishing procedures for testing of workwear |
| ISO 13938-1:1999 | Textiles Bursting properties of fabrics Part 1: Hydraulic method for determination of bursting strength and bursting distension |
| ISO 7000:2014 | Graphical symbols for use on equipment Registered symbols |
| ISO 4674-1:2016 | Rubber- or plastics-coated fabrics Determination of tear resistance Part 1: Constant rate of tear methods |
| EN ISO 6330:2012 | Textiles - Domestic washing and drying procedures for textile testing (ISO 6330:2012) |
| EN ISO 15831:2004 | Clothing - Physiological effects - Measurement of thermal insulation by means of a thermal manikin (ISO 15831:2004) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.