I.S. EN 1277:2004
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
View Superseded by
PLASTICS PIPING SYSTEMS - THERMOPLASTICS PIPING SYSTEMS FOR BURIED NON-PRESSURE APPLICATIONS - TEST METHODS FOR LEAKTIGHTNESS OF ELASTOMERIC SEALING RING TYPE JOINTS
Hardcopy , PDF
09-01-2019
English
18-07-2018
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
1 Scope
2 Principle
3 Apparatus
4 Test pieces
5 Test temperature
6 Procedure
7 Test report
Annex A (normative) Modification of test parameters
Provides three basic test pressures for determining the leaktightness of elastomeric sealing ring type joints for buried thermoplastics non-pressure piping systems.
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Withdrawn
|
| SupersededBy | |
| Supersedes |
This European standard specifies three basic test pressures for determining the leaktightness of elastomericsealing ring type joints for buried thermoplastics non-pressure piping systems.Unless otherwise specified in the referring standard, the methods pressures used are the following:— p1: internal negative air pressure (partial vacuum);— p2: a low internal hydrostatic pressure;— p3: a higher internal hydrostatic pressure.It also describes four test conditions under which the test can be executed, as follows:A: without any additional diametric or angular deflection;B: with diametric deflection;C: with angular deflection;D: with simultaneous angular and diametric deflection.These conditions can be applied individually or in combination. The applicable selection of the method(s)and the condition(s) should be specified in the referring standard.
| Standards | Relationship |
| UNI EN 1277 : 2005 | Identical |
| SN EN 1277 : 2004 | Identical |
| NF EN 1277 : 2004 | Identical |
| NS EN 1277 : 2ED 2004 | Identical |
| ONORM EN 1277 : 2004 | Identical |
| NBN EN 1277 : 2004 | Identical |
| EN 1277:2003 | Identical |
| NEN EN 1277 : 2004 | Identical |
| BS EN 1277:2003 | Identical |
| UNE-EN 1277:2004 | Identical |
| DIN EN 1277:2004-03 | Identical |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.