I.S. EN 1252-1:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
CRYOGENIC VESSELS - MATERIALS - PART 1: TOUGHNESS REQUIREMENTS FOR TEMPERATURES BELOW -80 DEGREE C
Hardcopy , PDF
07-11-2016
English
01-01-1998
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Definition
4 Toughness requirements
Annex A (informative) - A deviations
Annex ZA (informative) - Clauses of this European Standard
addressing essential requirements or other
provisions of EU directives
Describes the toughness requirements of metallic materials for use at a temperature below -80 degrees C to ensure their suitability for cryogenic vessels.
| DevelopmentNote |
COR 1998 issued on 12-07-2011. (07/2011)
|
| DocumentType |
Standard
|
| Pages |
16
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NBN EN 1252-1 : 1998 COR 1998 | Identical |
| NEN EN 1252-1 : 1998 C1 1999 | Identical |
| BS EN 1252-1:1998 | Identical |
| NF EN 1252-1 : 1998 | Identical |
| SN EN 1252-1 : 1999 CORR 1999 | Identical |
| NS EN 1252-1 : 1998 AC 1998 | Identical |
| UNE-EN 1252-1:1998 | Identical |
| UNI EN 1252-1 : 2000 | Identical |
| EN 10028-1:2017 | Flat products made of steels for pressure purposes - Part 1: General requirements |
| EN 485-3:2003 | Aluminium and aluminium alloys - Sheet, strip and plate - Part 3: Tolerances on dimensions and form for hot-rolled products |
| PREN 10028-7 : DRAFT 2013 | FLAT PRODUCTS MADE OF STEELS FOR PRESSURE PURPOSES - PART 7: STAINLESS STEELS |
| EN 10045-1 : 1990 | METALLIC MATERIALS - CHARPY IMPACT TEST - PART 1: TEST METHOD |
| EN 10028-4:2017 | Flat products made of steels for pressure purposes - Part 4: Nickel alloy steels with specified low temperature properties |
| EN 12163:2016 | Copper and copper alloys - Rod for general purposes |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.