I.S. CEN TR 14549:2004

1 Scope
2 Normative References
3 Terms and definitions
4 General
  4.1 Scope of the PED
  4.2 Responsibilities
  4.3 Fluid groups
  4.4 Conformity assessment categories
  4.5 Conformity assessment procedures
  4.6 Hazard analysis
5 Materials
  5.1 Material selection and appraisal
  5.2 Material certification
6 Design and calculation
  6.1 Allowable stresses
  6.2 Joint coefficients
  6.3 Isolation
7 Fabrication and installation
  7.1 Permanent joining (e.g. Welding)
  7.2 Traceability
  7.3 Documentation
      7.3.1 Marking and labelling
      7.3.2 Operating instructions
      7.3.3 Marking at take-off points
      7.3.4 Declaration of conformity
8 Inspection and testing
  8.1 Non-destructive tests
  8.2 Final inspection
9 Safety devices
Annex A (informative) Checklist of major actions arising
        from the PED
Annex B (informative) Key articles in the PED
      B.1 Introduction
      B.2 Table of Key Articles in the PED
Annex C (informative) Clauses of this guide addressing
        essential requirements or other provisions of the
        PED
Annex D (informative) Comparison of ISO 15649, ANSI/ASME
        B31.3 and PED annex I (Essential Safety Requirements)
      D.1 Introduction
      D.2 Comparison tables
          D.2.1 Contents of each table
          D.2.2 How to use the tables
Annex E (informative) Sources of further information and
        guidance
      E.1 Established guidelines
          E.1.1 General
          E.1.2 European Commission (CEC) guidelines
          E.1.3 Other guidelines
      E.2 Other sources of information
          E.2.1 Websites
          E.2.2 Published Guidance documents
          E.2.3 Miscellaneous sources
      E.3 Abbreviations

Defines a set of common additional and modified requirements to ISO 15649 and ANSI/ASME B31.3 necessitated by the PED. This Guide is intended for use in the petroleum, petrochemical and chemical industries.