EN ISO 14678:2005

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Guidance: Typical applications for the seven test
   methods are as follows:
5 Sampling
6 Safety
7 Method 1: Use of an applicator to apply a wet film
8 Method 2: Use of a plug former
9 Method 3: Use of a scraper
10 Method 4: Use of test blocks
11 Method 5: Flow from a lap joint
12 Method 6: Flow of adhesive through a hole
13 Method 7: Flow of structural adhesive films

ISO 14678:2005 describes seven methods for the assessment of the flow characteristics of adhesives after application at room temperature and during cure, by the measurement of sagging. These methods may be used both for specifying an adhesive and for quality control purposes.