EN ISO 13628-5:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, abbreviated terms and definitions
4 Functional requirements
5 Safety, design and testing philosophy
6 Design requirements
7 Component design, manufacture and test
8 Terminations and ancillary equipment design
9 Umbilical design
10 Umbilical manufacture and test
11 Factory acceptance tests
12 Storage
13 Pre-installation activity
14 Load-out
15 Installation operations
Annex A (informative) - Information that should be provided
        in a purchaser's functional specification
Annex B (informative) - Umbilical testing
Annex C (informative) - Hose and tube preferred sizes
Annex D (normative) - Characterization tests for hoses and
        umbilicals
Annex E (informative) - Fatigue testing
Annex F (informative) - Load-effect analysis
Annex G (informative) - Umbilical full-scale tests
Annex H (informative) - Tube material matrix
Annex I (informative) - Tube-wall thickness example
        calculation
Annex J (informative) - Buckling of metallic tubes
Bibliography

ISO 13628-5:2009 specifies requirements and gives recommendations for the design, material selection, manufacture, design verification, testing, installation and operation of umbilicals and associated ancillary equipment for the petroleum and natural gas industries. Ancillary equipment does not include top side hardware. Topside hardware refers to any hardware that is not permanently attached to the umbilical, above the topside hang-off termination.ISO 13628-5:2009 applies to umbilicals containing components, such as electrical cables, optical fibres, thermoplastic hoses and metallic tubes, either alone or in combination; and to umbilicals for static or dynamic service, with surface-surface, surface-subsea and subsea-subsea routings .ISO 13628-5:2009 does not apply to the associated component connectors, unless they affect the performance of the umbilical or that of its ancillary equipment.ISO 13628-5:2009 applies only to tubes with the following dimensions: wall thickness, t  6 mm, internal diameter, ID  50,8 mm (2 in). Tubular products greater than these dimensions can be regarded as pipe/linepipe and it is expected that they be designed and manufactured according to a recognised pipeline/linepipe standard.ISO 13628-5:2009 does not apply to a tube or hose rated lower than 7 MPa (1 015 psi), or to electric cable voltage ratings above standard rated voltages = 3,6/6(7,2) kV rms, where U0, U and Um are as defined in IEC 60502-1 and IEC 60502-2.