EN 15381:2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
  3.1 Terms and definitions
  3.2 Abbreviations
4 Required characteristics and corresponding
  test methods
  4.1 General
  4.2 Characteristics relevant to specific
      conditions of use
      4.2.1 General
      4.2.2 Alkaline resistance
      4.2.3 Melting point
      4.2.4 Resistance to weathering
5 Evaluation of conformity
  5.1 General
  5.2 Verification of values
  5.3 Initial type tests
  5.4 Factory production control
  5.5 Inspection
6 Marking
Annex A (normative) - Factory production control
      A.1 Items to be addressed in a factory
          production control system
          A.1.1 General
          A.1.2 Product design
          A.1.3 Production
          A.1.4 Finished products
          A.1.5 Applicable to A.1.2, A1.3 and A.1.4
                (to be used where appropriate)
      A.2 Checklist for the assessment of a factory
          production control system
          A.2.1 General
          A.2.2 Checklist
Annex B (normative) - Durability aspects
      B.1 Weathering
      B.2 Alkaline resistance
      B.3 Corrosion resistance
Annex C (normative) - Test method for the determination
        of the bitumen retention in paving fabrics used
        in pavements and asphalt overlays
      C.0 Introduction
      C.1 Scope
      C.2 Test specimens
          C.2.1 Handling
          C.2.2 Selection
          C.2.3 Number and dimensions
          C.2.4 Condition of specimens
      C.3 Testing procedure
      C.4 Test report
Annex D (normative) - Tensile test on steel wire mesh
Annex ZA (informative) - Clauses of this European
      Standard addressing the provisions of the EU
      Construction Products Directive
      ZA.1 Scope and relevant characteristics
      ZA.2 Procedure for the attestation of conformity
           of geotextiles and geotextile-related products
           used in pavements and asphalt overlays
           ZA.2.1 Systems of attestation of conformity
           ZA.2.2 Certificate and declaration of conformity
      ZA.3 CE-marking and labelling
Bibliography

This European Standard specifies the relevant characteristics of metallic and non-metallic geotextiles and geotextile-related products used in the construction of pavements and asphalt overlays and the appropriate test methods to determine these characteristics. The intended use of these geotextiles and geotextile-related products is to fulfil one or more of the following functions: reinforcement, stress relief and barrier. The use of geotextiles and geotextile-related products is to be considered as a part of an interlayer and asphalt overlay system.This standard is not applicable to geosynthetic barriers, as defined in EN ISO 10318.This standard provides for evaluation of conformity of the product to this European Standard and for factory production control procedures.This standard defines requirements to be met by manufacturers and distributors with regard to the presentation of product properties.NOTE 1Particular application cases or national specifications may contain additional requirements regarding product application or installation and specifying preferably standardized test methods, if they are technically relevant and not conflicting with European Standards.