EN 14064-1:2010

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Requirements
5 Test methods
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
Annex A (normative) Determination of the declared values of
        thermal resistance and thermal conductivity
Annex B (normative) Factory production control
Annex C (normative) Specimen preparation method for thermal
        resistance and thermal conductivity test
Annex D (normative) Specimen preparation method for water
        absorption test
Annex E (normative) Specimen preparation method for airflow
        resistivity test
Annex F (normative) Testing for reaction to fire of products
Annex G (normative) Testing for reaction to fire of products
        in standardised assemblies simulating end-use
        application(s)
Annex H (normative) Rules for creating performance charts for
        loose-fill insulation and examples of performance
        charts
Annex I (normative) Verification of performance chart according
        to Annex H (normative)
Annex J (normative) Specimen preparation method for coverage
        and density measurement
Annex K (normative) Thermal insulating products for lofts -
        Determination of settlement for blown loose fill
        insulation
Annex L (informative) Masonry cavity walls - Method for
        determining suitable spacings for blowing holes
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive
Bibliography

This European Standard specifies the requirements for blown loose-fill mineral wool products for in-situ installation in lofts, masonry cavity walls and frame constructions.This European standard is a specification for the insulation products before installation. It describes the product characteristics and includes procedures for testing, marking and labelling.This document does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.NOTETo avoid water penetration in masonry walls special tests adjusted to local climate might be needed.This document does not cover factory made mineral wool (MW) insulation products or in-situ products intended to be used for the insulation of building equipment and industrial installations.Products with a declared thermal resistance lower than 0,25 m².K/W or a declared thermal conductivity greater than 0,060 Wm/(m.K) at 10 °C are not covered by this document.This document does not cover products intended for airborne sound insulation and for acoustic absorption applications.