EN 13787:2001

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Characteristics
  4.1 General requirements
  4.2 Additional characteristics
5 Test methods for general requirements
  5.1 General conditions of testing
  5.2 Hardness
  5.3 Tensile strength and elongation at break
  5.4 Compression set
  5.5 Resistance to ageing
  5.6 Resistance to gas
  5.7 Resistance to lubricants
Annex A (informative) Additional characteristics
      A.1 General
      A.2 Resistance to ozone
      A.3 Resistance to abrasion
      A.4 Resistance to tear
Annex B (normative) Special national conditions
      B.1 Special national conditions
      B.2 Special national condition for Sweden
Bibliography

This European Standard specifies the minimum requirements for elastomeric materials intended to be used as static seals, dynamic seals or diaphragms in the gas pressure regulators covered by EN 334 and in the safety devices for gas pressure regulating stations and installations covered by the corresponding European Standards, as well as the relevant test methods to assess these requirements.This European Standard applies to elastomeric materials for use with gases of the first and second gas families to EN 437, for inlet pressures less than or equal to 100 bar, and in an operating temperature range between -10 °C, (or -20 °C when applicable), and +60 °C.This European Standard also gives some additional characteristics and recommendations for their application likely to be requested for elastomers in the order specifications, and the corresponding test methods (see informative Annex A).This European Standard only applies for type testing.