EN 13381-1:2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Test methods for determining the contribution to the fire resistance of structural members - Part 1: Horizontal protective membranes
08-07-2020
24-09-2014
Foreword
1 Scope
2 Normative references
3 Terms and definitions, symbols
and units
4 Test equipment
5 Test conditions
6 Test specimens
7 Installation of the test construction
8 Conditioning
9 Application of instrumentation
10 Test procedure
11 Test results
12 Test report
13 Assessment
14 Report of the assessment
15 Limits of applicability of the results
of the assessment
Annex A (normative) - Exposure to a semi-natural fire
Annex B (normative) - Measurement of properties of
horizontal protective membranes and components
Annex C (normative) - Test method to the smouldering
fire (slow heating curve)
Bibliography
This European Standard specifies a test method for determining the ability of a horizontal protective membrane, when used as a fire resistant barrier, to contribute to the fire resistance of standard horizontal structural building members as defined in 6.4.2.Test of horizontal protective membrane installed under a specific non-standard floor should be tested according to EN 1365-2.This European Standard contains the fire test which specifies the tests which are carried out whereby the horizontal protective membrane, together with the structural member to be protected, is exposed to a fire test according to the procedures defined herein. The fire exposure, to the temperature/time curve given in EN 1363-1, is applied from below the membrane itself.The test method makes provision, through specified optional additional procedures, for the collection of data which can be used as direct input to the calculation of fire resistance according to the processes given within EN 1992-1-2, EN 1993-1-2, EN 1994-1-2 and EN 1995-1-2.This European Standard also contains the assessment which provides information relative to the analysis of the test data and gives guidance for the interpretation of the results of the fire test, in terms of loadbearing capacity criteria of the protected horizontal structural member.In special circumstances, where specified in national building regulations, there can be a need to subject the protection material to a smouldering curve. The test for this and the special circumstances for its use are detailed in Annex C.The limits of applicability of the results of the assessment arising from the fire test are defined, together with permitted direct application of the results to different structures, membranes and fittings.This European Standard applies only where there is a gap and a cavity between the horizontal protective membrane and the structural building member. Otherwise, the test methods in prEN 13381-3, EN 13381-4 or prEN 13381-5, as appropriate, apply.Tests should be carried out without additional combustible materials in the cavity.Annex A gives details of assessing the performance of the ceiling when exposed to a semi-natural fire.
Committee |
CEN/TC 127
|
DevelopmentNote |
Supersedes CEN/TS 13381-1 & PREN 13381-1. (09/2014)
|
DocumentType |
Standard
|
PublisherName |
Comite Europeen de Normalisation
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
Standards | Relationship |
SN EN 13381-1 : 2014 | Identical |
I.S. EN 13381-1:2014 | Identical |
UNI EN 13381-1 : 2014 | Identical |
UNE-EN 13381-1:2016 | Identical |
DIN EN 13381-1:2014-12 | Identical |
NEN EN 13381-1 : 2014 | Identical |
NF EN 13381-1 : 2014 | Identical |
BS EN 13381-1:2014 | Identical |
NBN EN 13381-1 : 2014 | Identical |
NS EN 13381-1 : 2014 | Identical |
ONORM EN 13381-1 : 2014 | Identical |
15/30302476 DC : 0 | BS EN 13501-2 - FIRE CLASSIFICATION OF CONSTRUCTION PRODUCTS AND BUILDING ELEMENTS - PART 2: CLASSIFICATION USING DATA FROM FIRE RESISTANCE TESTS, EXCLUDING VENTILATION SERVICES |
DIN EN 13381-5:2015-02 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 5: APPLIED PROTECTION TO CONCRETE/PROFILED SHEET STEEL COMPOSITE MEMBER |
UNE-EN 13381-3:2016 | Test methods for determining the contribution to the fire resistance of structural members - Part 3: Applied protection to concrete members |
UNI EN 13381-5 : 2014 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF - STRUCTURAL MEMBERS - PART 5: APPLIED PROTECTION TO CONCRETE/PROFILED SHEET STEEL COMPOSITE MEMBER |
14/30287827 DC : 0 | BS EN 1364-2 - FIRE RESISTANCE FOR TESTS FOR NON-LOADBEARING ELEMENTS - PART 2: CEILINGS |
BS EN 13381-3:2015 | Test methods for determining the contribution to the fire resistance of structural members Applied protection to concrete members |
EN 13501-2:2016 | Fire classification of construction products and building elements - Part 2: Classification using data from fire resistance tests, excluding ventilation services |
EN 13381-3:2015 | Test methods for determining the contribution to the fire resistance of structural members - Part 3: Applied protection to concrete members |
EN 13381-5:2014 | Test methods for determining the contribution to the fire resistance of structural members - Part 5: Applied protection to concrete/profiled sheet steel composite member |
I.S. EN 13381-3:2015 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 3: APPLIED PROTECTION TO CONCRETE MEMBERS |
08/30189150 DC : 0 | BS EN 13381-4 - TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 4: APPLIED PASSIVE PROTECTION PRODUCTS TO STEEL MEMBERS |
I.S. EN 13501-2:2016 | FIRE CLASSIFICATION OF CONSTRUCTION PRODUCTS AND BUILDING ELEMENTS - PART 2: CLASSIFICATION USING DATA FROM FIRE RESISTANCE TESTS, EXCLUDING VENTILATION SERVICES |
UNE-EN 13381-5:2016 | Test methods for determining the contribution to the fire resistance of structural members - Part 5: Applied protection to concrete/profiled sheet steel composite member |
I.S. EN 13381-5:2014 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 5: APPLIED PROTECTION TO CONCRETE/PROFILED SHEET STEEL COMPOSITE MEMBER |
EN 1364-2:2018 | Fire resistance tests for non-loadbearing elements - Part 2: Ceilings |
BS EN 13501-2 : 2007 | FIRE CLASSIFICATION OF CONSTRUCTION PRODUCTS AND BUILDING ELEMENTS - PART 2: CLASSIFICATION USING DATA FROM FIRE RESISTANCE TESTS, EXCLUDING VENTILATION SERVICES |
DIN EN 13381-3:2015-06 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 3: APPLIED PROTECTION TO CONCRETE MEMBERS |
PREN 13501-2 : DRAFT 2015 | FIRE CLASSIFICATION OF CONSTRUCTION PRODUCTS AND BUILDING ELEMENTS - PART 2: CLASSIFICATION USING DATA FROM FIRE RESISTANCE TESTS, EXCLUDING VENTILATION SERVICES |
BS EN 13381-5:2014 | Test methods for determining the contribution to the fire resistance of structural members Applied protection to concrete/profiled sheet steel composite member |
PREN 1364-2 : DRAFT DEC 2014 | FIRE RESISTANCE FOR TESTS FOR NON-LOADBEARING ELEMENTS - PART 2: CEILINGS |
I.S. EN 1364-2:2018 | FIRE RESISTANCE FOR TESTS FOR NON-LOADBEARING ELEMENTS - PART 2: CEILINGS |
ISO 8421-2:1987 | Fire protection — Vocabulary — Part 2: Structural fire protection |
EN 13381-4:2013 | Test methods for determining the contribution to the fire resistance of structural members - Part 4: Applied passive protection to steel members |
EN 823:2013 | Thermal insulating products for building applications - Determination of thickness |
ISO 13943:2017 | Fire safety — Vocabulary |
EN 312:2010 | Particleboards - Specifications |
PREN 13381-2 : DRAFT 2012 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 2: VERTICAL PROTECTIVE MEMBRANES |
EN ISO 13943:2017 | Fire safety - Vocabulary (ISO 13943:2017) |
EN 1363-1:2012 | Fire resistance tests - Part 1: General Requirements |
EN 1363-2:1999 | Fire resistance tests - Part 2: Alternative and additional procedures |
PREN 13381-5 : DRAFT 2011 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 5: APPLIED PROTECTION TO CONCRETE/PROFILED SHEET STEEL COMPOSITE MEMBERS |
PREN 13381-3 : DRAFT 2012 | TEST METHODS FOR DETERMINING THE CONTRIBUTION TO THE FIRE RESISTANCE OF STRUCTURAL MEMBERS - PART 3: APPLIED PROTECTION TO CONCRETE MEMBERS |
EN 1365-2:2014 | Fire resistance tests for loadbearing elements - Part 2: Floors and roofs |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.