Customer Support: 131 242

  • There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

DIN EN 61967-4:2006-07

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Integrated circuits - Measurement of electromagnetic emissions, 150 kHz to 1 GHz - Part 4: Measurement of conducted emissions - 1 ohm/150 ohm direct coupling method (IEC 61967-4:2002 + A1:2006); German version EN 61967-4:2002 + A1:2006

Available format(s)

Hardcopy , PDF

Superseded date

07-08-2023

Published date

01-07-2006

$200.66
Including GST where applicable

1 Scope
2 Normative references
3 Definitions
4 General
  4.1 Measurement basics
  4.2 RF current measurement
  4.3 RF voltage measurement at IC pins
  4.4 Assessment of the measurement technique
5 Test conditions
6 Test equipment
  6.1 Test receiver specification
  6.2 RF current probe specification
  6.3 Test of the RF current probe capability
  6.4 Matching network specification
7 Test set-up
  7.1 General test configuration
  7.2 Printed circuit test board layout
8 Test procedure
9 Test report
Annex A (normative) Probe calibration procedure
Annex B (informative) Classification of conducted emission
        levels
  B.1 Introductory remark
  B.2 General
  B.3 Definition of emission levels
  B.4 Presentation of results
Annex C (informative) Example of reference levels for
        automotive applications
  C.1 Introductory remark
  C.2 General
  C.3 Reference level
Annex D (informative) EMC requirements and how to use
        EMC IC measurement techniques
  D.1 Introduction
  D.2 Using EMC measurement procedures
  D.3 Assessment of the IC influence to the EMC behaviour
      of the modules
Annex E (informative) Example of a test set-up consisting
        of an EMC main test board and an EMC IC test board
  E.1 The EMC main test board
  E.2 EMC IC test board
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Figures
Tables

Specifies a method to measure the conducted electromagnetic emission (EME) of integrated circuits by direct radio frequency (RF) current measurement with a 1 ohm resistive probe and RF voltage measurement using a 150 ohm coupling network.

DocumentType
Standard
Pages
37
PublisherName
German Institute for Standardisation (Deutsches Institut für Normung)
Status
Superseded

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Need help?
Call us on 131 242, then click here to start a Screen Sharing session
so we can help right away! Learn more