DEFSTAN 01-5/13(2002) : 2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS
14-02-2005
12-01-2013
Preface
Introduction
Scope
WARNING
Related Documents
Service Authorities
Joint Service Designation Products
Joint Service Designations (JSD) - Definitions
Notes for Guidance
Hazard Information
International Standardization Agreements
Classification of Products
Viscosity Classifications
SAE Viscosity Classifications
ACEA Engine Oil Classification System
API Performance Classification
API Service Classification System
NLGI Classification
Classification of Gasolines (Motor)
Issuing Authorities
NATO Stock Numbers
Technical Terms and Abbreviations
Product Application Guide
Section 1A: OC - Compounded Oils
Section 1B: OEP - Extreme Pressure Oils
Section 1C: OM - Mineral Oils
Section 1D: OMD - Heavy Duty Engine Oils
Section 1E: OX - Fluids
Section 2 : XG - Greases
Section 3 : ZX - Specialities
Section 4 : PX - Corrosion Preventives
Section 5 : AL - Fluids, WTA and White Spirit
Section 6A: Fuels, Aviation Gasolines
Section 6B: Fuels, Aviation Turbine Fuels
Section 6C: Fuels, Automotive Gasolines
Section 6D: Fuels, Diesels
Section 6E: Fuels, Furnace Fuel Oils
Section 6F: Fuels, Heating and Lighting
Section 7 : Reference Fuels
General Index
Viscosity/Temperature Characteristics Charts
Gives guidance on the characteristics and uses of fuels, lubricants and associated products for the Ministry of Defence.
DevelopmentNote |
Supersedes DEFSTAN 01-5/12(1999). (06/2002)
|
DocumentType |
Standard
|
PublisherName |
UK Ministry of Defence Standards
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
DEFSTAN 02-748/2(2002) : 2002 | REQUIREMENTS FOR STRAINERS IN HM SURFACE SHIPS AND SUBMARINES |
DEFSTAN 02-718/1(2002) : 2002 | REQUIREMENTS FOR SEWAGE PLANT AND ANCILLARY EQUIPMENT IN HM SURFACE SHIPS AND SUBMARINES |
DEFSTAN 23-8/2(2001) : 2001 | WINTERIZATION - MILITARY LOGISTIC VEHICLES, TOWED EQUIPMENT AND MECHANICAL HANDLING EQUIPMENT |
DEFSTAN 22-65/2(2001) : INTERIM | SPECIFICATION FOR GAUGES, SUBMARINE DEPTH, DIAL INDICATING |
DEFSTAN 03-29/3(2002) : 2002 | PROTECTION OF METALLIC SPRINGS AGAINST CORROSION |
DEFSTAN 02-319/2(2002) : INTERIM | REQUIREMENTS FOR AVIATION FUEL SYSTEMS IN HM SURFACE SHIPS |
DEFSTAN 02-373/2(2003) : 2003 | CODE OF PRACTICE FOR COMPRESSED AIR SYSTEMS CLEANLINESS CATEGORY 2 |
DEFSTAN 00-35(PT6)/3(2000) : 2000 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 6: INDUCED CLIMATIC, CHEMICAL AND BIOLOGICAL ENVIRONMENTS |
DEFSTAN 59-71(PT1)/2(1993) : 1993 | CRIMPED ELECTRICAL CONNECTORS FOR COPPER CONDUCTORS - PART 1: GENERAL REQUIREMENTS |
DEFSTAN 02-323/2(2001) : 2001 | REQUIREMENTS FOR CENTRIFUGES |
DEFSTAN 60-1(PT0)/2(2000) : 2000 | CABLES, FIBRE OPTIC - PART 0: GENERAL REQUIREMENTS AND TEST METHODS |
DEFSTAN 02-305/2(2003) : 2003 | REQUIREMENTS FOR GEARING - MAIN PROPULSION |
DEFSTAN 02-314/2(2001) : INTERIM | COMPRESSED AIR SYSTEMS |
DEFSTAN 68-189/2(2004) : 2004 | SOLVENT FOR GREASE, EMULSIFIABLE |
DEFSTAN 47-32/1(2002) : 2002 | RUBBER HOSE AND HOSE ASSEMBLIES FOR HYDRAULIC SYSTEMS |
DEFSTAN 02-113(PT7)/2(2002) : 2002 | REQUIREMENTS FOR MECHANICAL HANDLING - PART 7: LEVER HOISTS |
DEFSTAN 02-113(PT10)/2(2002) : 2002 | REQUIREMENTS FOR MECHANICAL HANDLING - PART 10: NON-TRAVERSING HAND OPERATED CHAIN BLOCKS AND THEIR ASSOCIATED NON-GEARED OVERHEAD RUNWAY TROLLEYS |
DEFSTAN 02-327/2(2001) : INTERIM | REQUIREMENTS AND GUIDANCE FOR THE PROCUREMENT OF PUMPS FOR AUXILIARY SYSTEMS |
DEFSTAN 81-41(PT2)/5(2002) : 2002 | PACKAGING OF DEFENCE MATERIEL - PART 2: DESIGN |
DEFSTAN 02-339/2(2002) : INTERIM | REQUIREMENTS FOR STEERING AND STABILIZER SYSTEMS FOR HM SURFACE SHIPS AND ROYAL FLEET AUXILIARIES |
DEFSTAN 23-6/3(2000) : 2000 | GUIDE TO THE COMMON TECHNICAL REQUIREMENTS FOR MILITARY LOGISTIC VEHICLES AND TOWED EQUIPMENT |
DEFSTAN 47-2/4(1997) : 1997 | RUBBER HOSE AND HOSE ASSEMBLIES FOR HYDRAULIC SYSTEMS (THICK COVER) |
DEFSTAN 02-605(PT1)/2(2003) : 2003 | GUIDE TO SELECTION OF SENSORS FOR MEASUREMENT OF SYSTEM PARAMETERS - PART 1: SELECTION OF LIQUID LEVEL, TEMPERATURE AND PRESSURE SENSORS |
DEFSTAN 80-158/3(2004) : 2004 | PAINT SYSTEM, EROSION RESISTING FOR AIRCRAFT, POLYURETHANE, MULTI-PACK, VOC COMPLIANT |
DEFSTAN 02-320/2(2002) : INTERIM | REQUIREMENTS FOR THE DESIGN AND INSTALLATION OF FUEL SYSTEMS FOR GAS TURBINE ENGINES AND DIESEL ENGINES IN HM SURFACE SHIPS AND SUBMARINES |
DEFSTAN 91-66/2(1995) : 1995 | THE SEGREGATION, HANDLING AND QUALITY ASSURANCE OF PETROLEUM FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS |
DEFSTAN 05-46/2(1982) : 1982 | DETERMINATION OF PARTICULATE MATTER IN HYDRAULIC FLUIDS USING AN AUTOMATIC PARTICLE SIZE ANALYSER EMPLOYING THE LIGHT INTERRUPTION PRINCIPLE |
DEFSTAN 05-43/1(1977) : 1977 | STANDARD PROCEDURES FOR TAKING SAMPLES OF HYDRAULIC FLUIDS FOR EVALUATION OF PARTICULATE CONTAMINATION |
DEFSTAN 02-316/2(2003) : 2003 | REQUIREMENTS FOR COMPRESSED AIR PURIFICATION EQUIPMENT |
DEFSTAN 05-45/1(1978) : 1978 | SIZING AND COUNTING PARTICULATE CONTAMINATION IN HYDRAULIC SYSTEM FLUID USING A BACK PROJECTION MICROSCOPE |
DEFSTAN 02-304(PT5)/2(2002) : 2002 | SHAFTING SYSTEMS AND PROPULSORS - PART 5: REQUIREMENTS FOR HANDLING, MAINTENANCE AND REPAIR OF PROPELLERS FOR HM SURFACE SHIPS |
DEFSTAN 02-322/2(2002) : 2002 | OIL AND BILGE WATER SHIPBOARD PROCESSING ARRANGEMENTS |
DEFSTAN 02-716/2(2002) : 2002 | REQUIREMENTS FOR WINTERIZATION ON HM SURFACE SHIPS |
STANAG 1425 : 2005 | GUIDE SPECIFICATION (MINIMUM QUALITY STANDARDS) FOR LUBRICATING OIL, STEAM TURBINE AND GEAR LIGHT SERVICE (O-240 AND O-253) |
STANAG 3149 : 2013 | MINIMUM QUALITY SURVEILLANCE FOR FUELS |
STANAG 1385 : 2010 | GUIDE SPECIFICATION (MINIMUM QUALITY STANDARDS) FOR NAVAL DISTILLATE FUELS (F-75 AND F-76) |
STANAG 7090 : 2007 | GUIDE SPECIFICATIONS FOR NATO GROUND FUELS |
STANAG 7071 : LATEST | DESIGN AND PERFORMANCE CRITERIA FOR AVIATION FUEL ADDITIVE INJECTION EQUIPMENT |
STANAG 3748 : 1995 | HYDRAULIC FLUIDS, PETROLEUM (H-515, H-520 AND C-635) AND POLYALPHAOLEFIN (H-537, H-538 AND H-544) |
STANAG 1414 : 2009 | GUIDELINES TO ENSURE THAT CONTRACTORS DESIGN AND SUPPLY NEW EQUIPMENT CAPABLE OF USING STANDARDIZED FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS |
STANAG 3747 : 2016 | GUIDE SPECIFICATIONS (MINIMUM QUALITY STANDARDS) FOR AVIATION TURBINE FUELS (F-24, F-27, F-34, F-35, F-37, F-40 AND F-44) |
STANAG 4362 : 2012 | FUELS FOR FUTURE GROUND EQUIPMENT USING COMPRESSION IGNITION OR TURBINE ENGINES |
STANAG 7063 : 2002 | METHODS OF DETECTION AND TREATMENT OF FUELS CONTAMINATED BY MICRO-ORGANISMS |
STANAG 3390 : 2015 | GUIDE SPECIFICATION AND INSPECTION STANDARDS FOR FUEL SOLUBLE LUBRICITY IMPROVERS (S-1747) |
STANAG 7093 : 2015 | GUIDE SPECIFICATION FOR NATO LAND SYSTEM AUTOMOTIVE FLUIDS |
STANAG 7091 : 2016 | GUIDE SPECIFICATION FOR NATO LAND SYSTEM OILS FOR ENGINES AND TRANSMISSIONS |
STANAG 7036 : 97 AMD 1 | FUELS TO BE INTRODUCED INTO AND DELIVERED BY THE NATO PIPELINE SYSTEM (NPS) |
STANAG 1135 : 2017 | INTERCHANGEABILITY OF FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS USED BY THE ARMED FORCES OF THE NORTH ATLANTIC TREATY NATIONS |
STANAG 1110 : 2012 | ALLOWABLE DETERIORATION LIMITS FOR NATO ARMED FORCES FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.