DEFSTAN 00-970(PT9)/4(2006) : 2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 9: UAV SYSTEMS
Hardcopy , PDF
20-04-2009
English
01-01-2006
PREFACE
SECTION 1 - GENERAL REQUIREMENTS
Clause 1.1 Introduction and Purpose
Clause 1.2 Applicability and Scope
Clause 1.3 Definitions
Clause 1.4 Referenced Documents
SECTION 2 - SYSTEM CHARACTERISTICS
Clause 2.1 Operational Colouring and Marking
Clause 2.2 General Operational Environmental Conditions
Clause 2.3 Reliability and Maintenance
Clause 2.4 Safety Management
Clause 2.5 Software
Clause 2.6 Electro-Magnetic Compatibility
Clause 2.7 Electronic Counter Measures (ECM) Resistance
Clause 2.8 Electronics
Clause 2.9 Range Interfacing
Clause 2.10 Design and Assembly of Components
Clause 2.11 Health Monitoring
Clause 2.12 Guidance and Control Systems
SECTION 3 - SUPPORT FACILITIES
Clause 3.1 General Requirements
Clause 3.2 Specific Climatic Conditions
Clause 3.3 Launch and Recovery Systems
Clause 3.4 Control Station
Clause 3.5 Maintenance
SECTION 4 - UNMANNED AIR VEHICLE
Clause 4.1 General Requirements
Clause 4.2 Climatic Conditions
Clause 4.3 Flight Performance
Clause 4.4 Structural Strength Requirements
Clause 4.5 Airframe
Clause 4.6 Powerplant
Clause 4.7 Avionics
Clause 4.8 Flight Termination
Clause 4.9 Payload
Clause 4.10 Electrical Installation and Wiring
Clause 4.11 Installation of Accident/Incident Flight Data
Recorder
SECTION 5 - DESIGN QUALIFICATION
Clause 5.1 General Principles of Design Qualification
Clause 5.2 Evaluation and Validation of the UAV System
Clause 5.3 Evaluation and Validation of Support Facilities
Clause 5.4 Evaluation and Validation of Air Vehicle and
Payloads
Provides Design and Airworthiness guidance for both the contractor/designer and the MoD Integrated Project Team.
DevelopmentNote |
Supersedes DEFSTAN 00-970(PT9)/3(2003) (04/2006)
|
DocumentType |
Standard
|
Pages |
244
|
PublisherName |
UK Ministry of Defence Standards
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
BS 381C:1996 | Specification for colours for identification, coding and special purposes |
DEFSTAN 05-37/2(1989) : 1989 | THE POLICY FOR THE PROCUREMENT OF ELECTRONIC COMPONENTS |
DEFSTAN 05-124/1(1992) : 1992 | PROCEDURES FOR THE PROCUREMENT OF AIRCRAFT ENGINES AND THEIR ACCESSORIES |
DEFSTAN 00-13/3(1994) : 1994 | REQUIREMENTS FOR THE ACHIEVEMENT OF TESTABILITY IN ELECTRONIC AND ALLIED EQUIPMENT |
DEFSTAN 61-17/4(2001) : 2001 | THE SELECTION AND INTRODUCTION OF BATTERIES FOR SERVICE USE |
DEFSTAN 05-18/4(1985) : 1985 AMD 2 1987 | SYMBOL MARKINGS OF SERVICING AND SAFETY/HAZARD POINTS ON AIRCRAFT, GROUND SUPPORT EQUIPMENT AND GUIDED WEAPONS SYSTEMS |
DEFSTAN 81-24/5(2004) : 2004 | IDENTIFICATION MARKING OF TRANSPORTABLE CONTAINERS, COMPRESSED GAS |
DEFSTAN 00-26/2(1988) : 1988 | GUIDE TO THE EVALUATION AND EXPRESSION OF THE UNCERTAINTIES ASSOCIATED WITH THE RESULTS OF ELECTRICAL MEASUREMENTS |
STANAG 2402 : 0 | DANGER AREAS FOR LAND LAUNCHED UNMANNED AERIAL VEHICLES FOR USE BY NATO FORCES OPERATING IN A GROUND ENVIRONMENT ON MILITARY RANGES |
DEFSTAN 00-49/1(1996) : 1996 | RELIABILITY AND MAINTAINABILITY MOD GUIDE TO TERMINOLOGY DEFINITIONS |
DEFSTAN 05-123/1(1983) : 1983 | TECHNICAL PROCEDURES FOR THE PROCUREMENT OF AIRCRAFT, WEAPON AND ELECTRONIC SYSTEMS |
STANAG 4324 : 2007 | ELECTROMAGNETIC RADIATION HAZARD ASSESSMENT AND TESTING OF MUNITIONS AND ASSOCIATED SYSTEMS |
STANAG 4360 : 2012 | SPECIFICATION FOR PAINT SYSTEMS, RESISTANT TO CHEMICAL AGENTS AND DECONTAMINANTS, FOR THE PROTECTION OF LAND MILITARY EQUIPMENT |
DEFSTAN 81-26/1(1974) : 1974 | CYLINDERS, COMPRESSED GAS FOR AIRCRAFT |
STANAG 4236 : 2007 | LIGHTNING ENVIRONMENT |
DEFSTAN 00-31/1(1987) : 1987 | THE DEVELOPMENT OF SAFETY CRITICAL SOFTWARE FOR AIRBORNE SYSTEMS |
STANAG 4235 : 0 | ELECTROSTATIC ENVIRONMENTAL CONDITIONS AFFECTING THE DESIGN OF MATERIEL FOR USE BY NATO FORCES |
BS 5852:1990 | Methods of test for assessment of the ignitability of upholstered seating by smouldering and flaming ignition sources |
STANAG 4327 : 0 | LIGHTNING, MUNITION ASSESSMENT AND TEST PROCEDURES |
STANAG 4145 : 1991 | NUCLEAR SURVIVABILITY CRITERIA FOR ARMED FORCES MATERIEL AND INSTALLATIONS - AEP-4 |
DEFSTAN 08-46/2(2002) : 2002 AMD 2 2004 | THE ELECTRIC, MAGNETIC AND ELECTROMAGNETIC ENVIRONMENT |
DEFSTAN 01-5/14(2005) : 2005 | FUELS, LUBRICANTS AND ASSOCIATED PRODUCTS |
DEFSTAN 00-55(PT2)/2(1997) : 1997 ERRATUM 1997 | REQUIREMENTS FOR SAFETY RELATED SOFTWARE IN DEFENCE EQUIPMENT - PART 2: GUIDANCE |
DEFSTAN 00-55(PT1)/2(1997) : 1997 | REQUIREMENTS FOR SAFETY RELATED SOFTWARE IN DEFENCE EQUIPMENT - PART 1: REQUIREMENTS |
DEFSTAN 00-3/3(1985) : 1985 | DESIGN GUIDANCE FOR THE TRANSPORTABILITY OF EQUIPMENT |
DEFSTAN 05-57/5(2005) : 2005 | CONFIGURATION MANAGEMENT OF DEFENCE MATERIEL |
DEFSTAN 08-41(PT2)/1(1998) : 1998 | CHEMICAL AND BIOLOGICAL HARDENING OF MILITARY EQUIPMENT - PART 2: THE PROPERTIES OF POLYMERIC MATERIALS EXPOSED TO CW AGENTS |
STANAG 4234 : 0 | ELECTROMAGNETIC RADIATION (RADIO FREQUENCY) - 200 KHz TO 40 GHz ENVIRONMENT - AFFECTING THE DESIGN OF MATERIEL FOR USE BY NATO FORCES |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.