CSA ISO/IEC TR 19782:14 (R2019)

1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Measurement procedures
6 Test reports
7 Impact of gloss and opacity effects on verification
Annex A (informative) - Example of gloss measurement
        technique
Annex B (informative) - Reporting of gloss measurements
Annex C (informative) - Opacity measurement

Describes guidelines to deal with the effects of substrate gloss and/or low opacity on the performance of bar code symbols when scanned by reading and verification systems.

CSA Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the Canadian Advisory Committee (CAC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. Also, as a member of the International Telecommunication Union (ITU), Canada participates in the International Telegraph and Telephone Consultative Committee (ITU-T). For brevity, this Standard will be referred to as \"CAN/CSA-ISO/IEC TR 19782\" throughout. This Standard has been formally approved, without modification, by the Technical Committee and has been approved as a National Standard of Canada by the Standards Council of Canada. Scope This Technical Report gives guidelines to deal with the effects of substrate gloss and/or low opacity on the performance of bar code symbols when scanned by reading and verification systems. This Technical Report defines methods of measurement for gloss and opacity; it identifies conditions and values that present a risk of reading problems and provides recommendations to users on the specification of substrates and the set-up of scanning systems to minimize these problems. It also addresses the relationship between verification results and read performance when either or both of the factors are present. This document is intended for those who specify or implement labeling systems and those involved in the reading of bar code symbols on packages, components and other carriers of bar code symbols.