CSA/ANSI Z21.8:1994

PART 1 - SCOPE
 1.1 Applicability
 1.2 Safe and Satisfactory Operation
 1.3 Installation
PART 2 - VISUAL INSPECTION
 2.1 Air for Combustion and Ventilation
 2.2 Combustion Chamber Liner
 2.3 Vent Connector
 2.4 Chimney
 2.5 Accessories
 2.6 Vent Damper Devices
 2.7 Electrical Supply Considerations
 2.8 Plate
PART 3 - SELECTION AND SIZING OF CONVERSION BURNER
 3.1 General
 3.2 Typical Conversion Burner Types
 3.3 Appliance Design Features
 3.4 Heat Loss Determination
 3.5 Input Rate Determination
 3.6 Preliminary Burner Selection
 3.7 Final Burner Selection
PART 4 - PREPARATION OF EXISTING HEATING PLANT
 4.1 Cleaning
 4.2 Reconditioning
 4.3 Combustion Chamber Linings
 4.4 Water Heating Coils
 4.5 Use of Asbestos
PART 5 - PREPARATION OF EXISTING HEATING SYSTEM
 5.1 Chimneys
 5.2 Vent Connector and Chimney Sizing
 5.3 Pitch
 5.4 Revertible Flues
 5.5 Support and Clearance
 5.6 Draft Hoods and Barometric Draft Regulators
 5.7 Vent Connection
PART 6 - GAS PIPING
 6.1 General
 6.2 Installation of piping
 6.3 Inspection and Testing of Piping
PART 7 - INSTALLATION OF BURNER
 7.1 Field Installation of Electrical Wiring
 7.2 System Safety and Limiting Devices
 7.3 Inspection of Burner and Controls
 7.4 Placement of Burner
PART 8 - START-UP AND ADJUSTMENT
 8.1 General
 8.2 Recommended Instruments
 8.3 Leak Test (Low Pressure)
 8.4 Input Adjustment and Orifice Pressure
 8.5 Adjustment of Draft
 8.6 Preliminary Adjustment of Combustion Air
 8.7 Final Adjustment
 8.8 Final Checking
PART 9 - COMPLETING THE INSTALLATION
 9.1 Oil Storage System
 9.2 Solid Fuel System
 9.3 Cleaning
 9.4 Instructions to Customers
 9.5 Placement of Manufacturer'sÆ instructions
 9.6 Installation Adjustment Data
 9.7 Gas Supplier Notification
EXHIBIT LIST OF REFERENCED STANDARDS
PART 10 - DEFINITIONS

Outlines installation requirements for domestic gas conversion burners which use natural, mixed, manufactured and liquefied petroleum gases and LP gas-air mixtures.